Инструкции для Aiko CTH3-80

Содержание

• SECTION 1: Heater Safety

  1
• 1.1 Manpower Requirements

  1
• 1.2 Safety Labels and Their Placement

  1
• 1.3 California Proposition 65

  1
• Figure 1: Top and Bottom Panel Label Placement

  2
• Figure 2: Side and Back Panel Label Placement

  3
• SECTION 2: Installer Responsibility

  4
• 2.1 Wall Tag

  4
• 2.2 Corrosive Chemicals

  4
• 2.3 National Standards and Applicable Codes

  4
• SECTION 3: Clearances to Combustibles

  5
• 3.1 Required Clearances to Combustibles

  5
• Figure 3: Standard Reflector

  5
• Figure 4: One Side Reflector

  6
• Figure 5: Two Side Reflectors

  6
• Figure 6: 45° Tilt Reflector

  6
• Figure 7: U-Tube, Standard Reflector

  7
• Figure 8: U-Tube, 45°

  7
• Figure 9: U-Tube, Opposite 45° Reflector

  7
• Figure 10: 2-Foot Deco Grille and Protective Grille

  8
• Figure 11: Lower Clearance Shield

  8
• Figure 12: Venting

  8
• SECTION 4: National Standards and Applicable Codes

  9
• 4.1 Gas Codes

  9
• 4.2 Aircraft Hangars

  9
• 4.3 Public Garages

  9
• 4.4 Electrical

  9
• 4.5 Venting

  9
• 4.6 High Altitude

  9
• SECTION 5: Major Components

  10
• Figure 13: Major Component Descriptions

  10
• 5.1 Standard Parts List

  11
• Table 1: Contents of Burner Carton

  11
• Table 2: Contents of Core and Extension Packages

  11
• Table 3: CTH3-Series Component Package Guide

  11
• SECTION 6: Heater Installation

  12
• Figure 14: Critical Hanger Placement

  13
• Figure 15: Linear Heater Assembly Overview

  14
• Figure 16: Linear Heater Layout Overview

  15
• 6.1 Burner Tube Installation

  16
• 6.2 Tube Clamp Package Installation

  16
• 6.3 Coupling and Tube Assembly

  17
• 6.4 Turbulator Installation

  18
• 6.5 Reflector Installation

  19
• 6.6 Burner Installation

  21
• SECTION 7: Optional Heater Accessories

  22
• 7.1 U-Tube Configuration

  22
• Figure 17: U-Tube Heater Assembly Overview

  23
• Figure 18: U-Tube Heater Layout Overview

  24
• 7.2 Elbow Package Configuration

  25
• Figure 19: Reflector Joint Detail

  26
• 7.3 Reflector Side Extension

  27
• 7.4 Lower Clearance Shield Installation

  28
• 7.5 Two-Foot Decorative Grille Installation

  28
• 7.6 Protective Grille Installation

  30
• SECTION 8: Venting

  31
• 8.1 Venting

  31
• 8.2 Unvented Operation

  31
• 8.3 Horizontal Venting

  32
• 8.4 Vertical Venting

  32
• 8.5 Unvented Operation Tube Termination

  32
• 8.6 Length Requirements

  32
• 8.7 Horizontal Ventilation 4" (10 cm) Pipe

  32
• Figure 20: Tube Termination

  32
• 8.8 Vertical Ventilation 4" (10 cm) Pipe

  33
• 8.9 Common Side Wall Venting

  33
• 8.10 Common Vertical Venting

  34
• 8.11 Outside Combustion Air Supply

  35
• SECTION 9: Gas Piping

  37
• Figure 21: Gas Connection with Flexible Gas Hose

  38
• SECTION 10: Wiring

  39
• 10.1 Standard Heater Configuration

  39
• Figure 22: Zone Sensor Wiring Diagram

  39
• Figure 23: Central Heater Jumper Settings

  40
• Figure 24: Satellite Heater Jumper Setting

  41
• 10.3 Communication Wiring within a Zone of Heaters

  42
• (continued)

  43
• (continued)

  43
• 10.4 Heat Demand Control Wiring

  44
• Figure 26: Thermostat Control Wiring Diagram

  44
• Table 4: Cable Requirements

  46
• Figure 27: Analog Control Signal Wiring Diagram

  47
• Figure 28: Potentiometer Control Wiring Diagram

  48
• (LonWorks [4-20 mA] optional)

  49
• optional)

  50
• with BACnet (optional)

  51
• 10.5 Internal Wiring

  52
• 10.6 Ladder Diagram

  53
• 10.7 Line Voltage Power Wiring

  54
• 10.8 Electrical Connection to the Burner

  54
• 10.9 Low Voltage Control Wiring Installation

  55
• SECTION 11: Operation and Maintenance

  56
• 11.1 Sequence of Operation

  56
• 11.2 To Shut Off Heater

  56
• 11.3 To Start Heater

  56
• 11.4 Pre-Season Maintenance and Annual Inspection

  56
• SECTION 12: Troubleshooting

  59
• 12.1 Control LED

  60
• 12.2 General LED Codes

  60
• 12.3 Troubleshooting Flow Chart

  62
• 12.4 Manifold Gas Pressure Measurement

  64
• 12.5 Pneumatic Connections

  65
• SECTION 13: Replacement Parts

  66
• SECTION 14: General Specifications

  69
• 14.1 Material Specifications

  69
• 14.2 Heater Specifications

  69
• 14.3 Suspension Specifications

  69
• 14.4 Controls Specifications

  69
• MODULATING Warranty

  71