Справочник ПользователяСодержаниеMaster Table of Contents6Safety2Section A - Installation7Section B - Operation17Section C - Accessiories25Section D - Maintenance33Section E - Theory of Operation41Section F - Troubleshooting and Repair49Symptoms52Major mechanical or electrical damage is evident.52No welding output or auxiliary power. The engine operates normally.52No welding output in any mode. The auxiliary output is normal. The engine operates normally.53No output in PIPE MODE. Outputs normal in other modes.54VRD lights don’t light up.54No auxiliary power at one or more receptacles or at the 14 pin Amphenol. Weld output is normal and the engine operates normally.54The machine has low welding output and low auxiliary output.54The machine will weld but the welding arc is “COLD”. The engine runs normally and the auxiliary power is normal.55The machine will weld but the welding arc is “COLD”. The engine runs normally and the auxiliary power is normal. (continued)56The machine welds but it will not maintain a steady output.56The machine welds but it will not maintain a steady output. (continued)57The weld output can not be adjusted with the front panel output control knob in one or mode weld modes. The weld output terminals have normal OCV (open circuit voltage). The AC auxiliary power is normal and the engine operated normally.58The machine front panel output control is still active when the remote control unit is connected to one of the Front Panel Amphenols.58The machine seems to be locked into the “CC-stick” mode of operation.59The arc quality is poor with excessive spatter. The arc heat can be controlled and maintained normally, the auxiliary output is normal and the engine operates normally.59The machine welds normally in all modes and the range of weld output seems normal, but one or both of the front panel displays is blank, incorrect welding value, or displays parts of numbers.60A control cable type feeder does not function when connected to the 14 pin amphenol. Machine operates normally in the “CC-STICK” mode and has normal AC auxiliary output.60An Across-the-Arc type wire feeder does not function when connected to the weld output of the machine. The Vantage® operated normallyin the CC-STICK mode, and has normal AC auxiliary output.61The engine will not crank when the start button is pushed.61The battery does not stay charged.62The engine cranks when the startbutton is pressed but will not start.62The engine starts but shuts down immediately when the start button is released.63The engine shuts down shortly after starting.63The engine shuts down shortly after starting.64The engine shuts down shortlyafter starting and trips the battery circuit breaker (CB5).64The engine will not develop ful lpower.65The engine will not idle down to low RPM. The machine has normal weld and auxiliary output.65The engine will not idle down to low RPM. The machine has normal weld and auxiliary output. (continued)66The engine will not idle down to low RPM. The machine has normal weld and auxiliary output. (continued)67The engine will not go to high idle when using auxiliary power. Auxiliary power is normal when the idler switch is in the “HIGH” idle position, the automatic idle function works properly when welding.67The engine will not go to high idle when striking arc. The automatic idle system functions normally when using auxiliary power. Welding and auxiliary outputs are normal when the idle switch is in the “HIGH IDLE” position.68The engine will not go to high idle when attempting to strike and arc, or when a load is applied to any of the auxiliary power receptacles.68The engine goes to low idle, but will not stay low idle.68Section G - Electrical Diagrams153Размер: 8,6 МБСтраницы: 166Язык: EnglishПросмотреть