Краткое Руководство По УстановкеСодержаниеStep 1: Prepare for Installation/Replacement1a. If this is a first-time installation, make sure you have the following system requirements:1b. Make sure you have the tools and equipment recommended for this procedure:1c. Check the FC310 kit using the Quantum|ATL FC310 Contents List.1d. Take precautions to prevent electrostatic discharge (ESD). These precautions include:1Step 2: Install the FC3102a. Turn off and unplug the library. (If this is a standalone library, remove the two screws holdi...2b. Loosen the two captive screws that secure the card cage to the back of the library.2c. Slide the card cage out of the library using the handle.2d. Locate the expansion slot closest to the SCSI adapter.2e. Carefully remove the new FC310 from its antistatic packaging. Hold the FC310 by the edges; avo...2f. Insert the FC310 into the expansion slot. Press down gently on the card edge until the card is...2g. Secure the FC310 to the card cage frame using the two screws provided.2h. Reattach the hold-down clamp to secure the card in the slot.2i. Slide the card cage back into the library and secure the cage by tightening the two captive sc...2j. If this is a standalone library, slide the cover back on the library and secure it in place.2Step 3: Connect SCSI CableS3a. Attach a SCSI cable from the upper SCSI port on the library SCSI controller to the first SCSI ...3b. Attach a SCSI cable from SCSI port 0 on the FC310 (the left VHDCI connector) to the lower SCSI...3c. If the library has two drives, attach a SCSI cable from SCSI port 1 on the FC310 (the right VH...3Step 4: Connect the Fibre Channel Cable3a. Connect one end of the Fibre Channel cable to the Fibre Channel port on the FC310.3b. Connect the other end of the Fibre Channel cable to the Fibre Channel port on an HBA installed...3Step 5: Starting Up/Self-Testing the FC3103a. Using the serial cable provided, establish a connection between the serial (RJ45) connector on...3b. Reconnect the library’s power cord to a grounded power outlet and then turn on the library.3c. When the library has powered up, turn on the host computer.3d. Make sure the COM port on the host computer has the following settings:3e. Run HyperTerminal or equivalent.3f. At the Ready prompt, type firmwarerestart and press <Enter>. This causes the firmware to resta...4Step 6: Configure the FC3104Размер: 204,0 КБСтраницы: 4Язык: EnglishПросмотреть
