Справочник ПользователяСодержание70-32818-01 Revision B — April 20012LS 2100 Product Reference Guide2Symbol Technologies, Inc. One Symbol Plaza, Holtsville N.Y. 117422Product Reference Guide1© 2001 by Symbol Technologies, Inc. All rights reserved.4No part of this publication may be reproduced or used in any form, or by any electrical or mechan...4The software is provided strictly on an “as is” basis. All software, including firmware, furnishe...4Symbol reserves the right to make changes to any software or product to improve reliability, func...4Symbol does not assume any product liability arising out of, or in connection with, the applicati...4No license is granted, either expressly or by implication, estoppel, or otherwise under any Symbo...4Symbol, Spectrum One, and Spectrum24 are registered trademarks of Symbol Technologies, Inc. Other...4Symbol Technologies, Inc. One Symbol Plaza Holtsville, New York 11742-1300 http://www.symbol.com4LS 2100 Undecoded Scanner Product Reference Guide3Contents5About This Guide7The LS 2100 Undecoded Scanner Product Reference Guide provides general instructions for the setup...7Notational Conventions7The following conventions are used in this document:7Related Publications7Service Information7If you have a problem with your equipment, contact the Symbol Support Center for your region. See...7Call the Support Center from a phone near the scanning equipment so that the service person can t...7If your problem cannot be solved over the phone, you may need to return your equipment for servic...8Note:8Symbol Support Center8For service information, warranty information or technical assistance contact or call the Symbol ...8If you purchased your Symbol product from a Symbol Business Partner, contact that Business Partne...9Warranty9Warranty Coverage and Procedure10General10Chapter 1 Setting Up the LS 210011Introduction11The LS 2100 Series of hand-held laser scanners offers excellent performance in retail and light i...11The LS 2100 Series hand-held scanner is based on the SE 1200 Series scan engine with Visible Lase...11Figure 1-1. LS 2100 Scanner11Here’s what each member of the LS 2100 family offers you:11All of the LS 2100 series scan automatically at the rate of 36 scans per second. For decode capab...12Audience12The intended audience for this manual is personnel performing installation/setup and programming ...12Unpacking12Remove the LS 2100 from its packing and inspect it for damage. If the scanner was damaged in tran...12Setting Up the LS 210013Installing the Cable13Insert the cable into the receptacle on the bottom of the scanner, as shown below:13Figure 1-2. Installing the Cable13Switching Cables13Different cables are required for different hosts. To change the scanner cable:131. Press the tab on the cable with a small screwdriver.132. Pull the cable out of the receptacle on the bottom of the scanner.133. Insert a new cable in the receptacle. Press the cable firmly into the receptacle until you hea...14Connecting to a Host14Plug the connector at the end of the LS 2100 cable into the appropriate port on the Symbol interf...14Figure 1-3. Connecting to a Host14Chapter 2 Scanning with the LS 210015Introduction15This chapter covers the proper techniques for scanning bar codes and the decode zone for the LS 2...15Scanning with the LS 2100151. Before you use the scanner, make sure all cable connections are secure.152. Make sure the bar code is in the correct scanning range. Aim and press the trigger; the scan b...15Figure 2-1. Holding the Scanner16Aiming the Scanner16Hold the scanner at an angle. Do not hold the scanner directly over the bar code. Laser light ref...16You can tilt the scanner up to 55° forward or back and achieve a successful decode. Simple practi...16Figure 2-1. Aiming the Scanner16What Does The Beep Mean?17When you hear 1 beep (short high tone) it means data has been decoded successfully. If any other ...17When the symbol has been decoded, you will hear a short, high-tone beep, and the green decode LED...17LS 2100 Decode Zone18Chapter 3 Maintenance and Specifications19Introduction19This chapter covers the appropriate methods for maintaining and the technical specifications for ...19Maintenance19Cleaning the exit window is the only maintenance required. A dirty window may affect scanning acc...19Troubleshooting19If, after following the operating instructions, the scanner does not work:19If after performing these checks the symbol still does not scan, contact your distributor or call...20Accessories20Standard Accessories:20Cables20Optional Accessories21Optional accessories, supplied at extra cost, include additional units of any item listed above a...21Technical Specifications21LS 2100 Signal Descriptions23The following signal descriptions apply to the connection between the scanner and the cable, and ...23PIN 124Figure 3-1. 10-pin Connector24Glossary25Размер: 406,5 КБСтраницы: 32Язык: EnglishПросмотреть
