Справочник ПользователяСодержаниеWater Resistant Personal Help Button1Product Summary1Assembly Guidelines1Assembly Options1Wall Mount11. Place the wall mount adapter on the wall at the desired location and mark through the mounting holes with a pencil.12. Secure the holder to the wall with #4 screws. Use plasterboard anchors where studs are not present.13. Snap the help button onto the four snap-on posts on the wall mount adapter.1Belt Clip1Wrist Bands11. Lay the hook and latch wrist band across the back of the help button.12. Compress the spring-loaded pins with a small screw driver13. Slip the pins over the wrist band and into the pin slots located on the back of the help button.11. Insert the spring-loaded pins through the ends of the plastic wrist band.22. Compress the spring-loaded pins with a small screw driver.23. Slip into the pin slots located on the back of the help button.2Pendant21. Make sure the necklace or chain fits through the larger hole in the pin-mounted necklace adapter.22. Remove one of the spring-loaded pins from the plastic wrist band and insert it into the smaller hole on the necklace adapter.23. Compress the spring-loaded pins with a small screw driver and slip them into the pin slots located on the back of the help button.21. Slip the rope necklace into the top slot on the pendant adapter and hook the plastic ends together.22. Snap the help button onto the four snap-on posts on the pendant adapter.2Programming21. Set the panel in the program mode.22. Enter the appropriate group number when prompted by the panel.23. Select the desired sensor number when prompted by the panel.24. When prompted by the panel to trip the sensor, press the help button until the light blinks.25. Exit from program mode.2Testing the Help Button21. Set the system to the Dealer Sensor Test mode.22. Activate the help button by grasping the help button in your hand pressing it with your thumb or finger until the light blinks.23. Listen for beeps sounded from system sirens. You should hear at least 7 beeps.24. Test the help button from several locations within the premises to check for consistent response.25. Instruct the user to test the help button weekly.2Repair of the Help Button31. Disassemble the help button by removing the four screws on the back of the help button and separate the cover and base.32. Remove the old battery from its holder and install the new battery, observing polarity.33. Reassemble the help button. Make sure to line up the LED indicator bump on the cover with the LED on the PCB.34. Test the help button as described in “Testing the Help Button” section.31. Disassemble the help button by removing the four screws on the back of the help button and separate the cover and base.32. Reassemble the help button using the new cover. Make sure to line up the LED indicator bump on the cover with the LED on the PCB.3Lithium Battery Disposal3Specifications4Notices4Размер: 217,9 КБСтраницы: 4Язык: EnglishПросмотреть
