Toro 4014-D 用户手册
Groundsmaster 4000--D/4010--D
Page 6 -- 16
Axles, Planetaries and Brakes
Rear Axle Assembly
1. Frame assembly
2. Cap screw (10 used)
3. Lock washer (6 used)
4. Flat washer (16 used)
5. Support frame
6. Thrust washer (thick)
7. Grease fitting
8. Rear axle assembly
9. Thrust washer (thin)
10. Washer head screw
11. Pivot pin
12. Rear axle mount
13. Washer
14. Lock nut
15. Flange nut (10 used)
16. Rear bumper
17. Hydraulic manifold (4WD)
18. Cap screw (2 used)
19. Flange nut (2 used)
20. Cap screw (6 used)
Figure 11
1
5
8
6
9
12
11
7
13
14
2
4
15
16
2
20
4
10
15
4
3
FRONT
RIGHT
17
18
19
See text for
tightening
procedure
Removal (Fig. 11)
1. Park machine on a level surface, lower cutting
decks, stop engine, apply parking brake and remove
key from the ignition switch.
CAUTION
When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
2. Chock front wheels and jack up rear of machine (see
Jacking Instructions in Chapter 1 -- Safety). Support ma-
chine with jack stands.
3. Drain oil from rear axle and axle gearbox.
4. Remove both wheels from rear axle.
5. Remove hydraulic motor from rear axle assembly
(see Rear Axle Motor Removal in the Service and Re-
pairs section of Chapter 4 -- Hydraulic System).
6. Remove steering cylinder from rear axle (see Steer-
ing Cylinder Removal in the Service and Repairs section
of Chapter 4 -- Hydraulic System).
7. Disconnect both steering cylinder hydraulic hoses
from hydraulic tubes at rear axle mount bracket (Fig.
12). Remove bulkhead lock nuts that secure steering
cylinder hydraulic tubes to bracket. Separate tubes from
axle mount bracket.