Bowflex 1000 用户手册

Assembly Manual

 

•   TreadClimber® Base and Treadle assembly from Step 14

 

•  (2) Treadle Decals

 

•  (2) Drive Cover Decals

 

•  #2 Phillips Head Screwdriver (included)

15-1   Clean the application surface with a wet cloth and dry 

thoroughly with a towel.

15-2   Remove the relase backing on the decal.
15-3   Center the decal on the appropriate application surfaces 

(See Figure 15-1) for locations.

15-4   Rub the decal onto the surface to force out the air bubbles.

 16-1   Inspect your machine to make sure that all of it has been 

assembled correctly, there are no loose or missing parts 
and that all of the hardware has been tightened.

17-1   Make sure that the Main Power Switch is in the “Off” 

postition.

17-2   Carefully insert the power cord into the Incoming Power Plug 

at the rear of the base unit (See Figure 17-1).

Note:   Always plug cord into the base before plugging into the 

wall outlet.

Note:   The TreadClimber

®

 machine plugs into any standard, 

grounded (three-prong) wall outlet.

 NEVER remove the grounding prong from the power plug 
and never use a two-prong adapter without a grounding 
wire.

 

 Failure to visually check and test assembly 

before use can cause damage to the 

TreadClimber

®

 machine and serious injury 

to users and bystanders and can also 

compromise the effectiveness of your exercise 

program.