Teledyne Percent Oxygen Analyzer 用户手册
Introduction Model
9060L
Teledyne Analytical Instruments
14
Figure 1-2 Rear Panel
• Power Connection 110 VAC at 50/60 Hz. The connector
housing includes the fuse holder and the
power switch. (220VAC is optional via
setting an internal switch).
Fuse Holder: Replacing the fuse is
described in Chapter 5, Maintenance.
I/O Power Switch: Turns the instrument
power ON (1) or OFF (0).
power switch. (220VAC is optional via
setting an internal switch).
Fuse Holder: Replacing the fuse is
described in Chapter 5, Maintenance.
I/O Power Switch: Turns the instrument
power ON (1) or OFF (0).
• Analog Outputs
0–10 VDC concentration output.
0–10 VDC range ID (or optional
overrange) output.
4–20 mA DC concentration output,
negative ground.
0–10 VDC range ID (or optional
overrange) output.
4–20 mA DC concentration output,
negative ground.
• Alarm Connections Alarm 1 (HI alarm), Alarm 2 (LO alarm),
and Probe Failure Alarm connections.
• Sensor Connector For connecting the probe’s Oxygen
sensor.
• Heater Connector For connecting the probe’s heater