Multiquip FCG1-6HA 用户手册
FCG16HA SAW • OPERATION AND PARTS MANUAL — REV. #1 (03/19/10) — PAGE 15
Figures 3 shows the location of the basic controls or components,
for the FCG16HA Concrete Saw. Listed below is a brief
explanation of each control or component
for the FCG16HA Concrete Saw. Listed below is a brief
explanation of each control or component
1.
Hand Grips/Handlebar – When operating the saw, place
both hands on each grip to maneuver the saw.
both hands on each grip to maneuver the saw.
2.
Adjustable Handle – Set to comfortable operating position.
3.
Rear Guide – Rear guide wheel drops into cut to assist in
straight tracking.
straight tracking.
4.
Air Filter – Prevents dirt and debris from entering the engine
air intake. Keep cleaned and replace when necessary.
air intake. Keep cleaned and replace when necessary.
5.
Recoil Starter Handle – Pull to engage and start the
engine.
engine.
6.
Recoil Starter Assembly – Engages the engine when
the handle is pulled and rewinds the starter rope when the
handle is released.
the handle is pulled and rewinds the starter rope when the
handle is released.
7.
Wheels/Carraige Assembly – Heavy-duty polyurethane
wheels with permanently sealed ball bearings.
wheels with permanently sealed ball bearings.
COMPONENTS
8.
Diamond Blade – 0.675" (15.9 mm) Arbor diameter. 10"
blade capacity. 10" diameter provides for 1/4" to 3 1/4"
depth of cut. MAX Width blade is .375" (9.5 mm).
blade capacity. 10" diameter provides for 1/4" to 3 1/4"
depth of cut. MAX Width blade is .375" (9.5 mm).
9.
Blade Guard – Covers saw blade and flips up to allow
blade to be changed.
blade to be changed.
10. Belt Tension Adjuster – Adjusts belt tension.
11. Front Pointer – Assists in straight tracking.
12. Front Pointer Arm – Pivots up for storage and pivots down
for use.
13. Depth Adjust Disk – Turn disk clockwise or counter-
clockwise to adjust the cutting depth up or down.
14. Fuel Tank – Use unleaded gasoline. Do not overfill.
15. Shift Knob – Moves Depth Stop Rod in or out of keyhole
slot.
16. V-Belt Cover – Remove this cover to gain access to the V-
belt. NEVER operate the saw with this cover removed.
17. Arbor Shaft Grease Zerks – Conveniently located for
lubrication.
18. On/Off Switch (Engine)– Turn to the "ON" position to
allow engine to be started and turn to the "OFF" position to
prevent accidental starting.
prevent accidental starting.
19. Handle Lock – Lock handle height to a comfortable
operating position.
20. Screw Plunger – Line up bottom edge of Depth Stop Rod
on Screw Plunger across from desired depth line mark.
21. Depth Stop Rod – Holds blade above working surface or
allows blade to cut into working surface at specified depth.
22. Engine Shut-off Switch – The Engine Shutdown Switch
located next to the handle lock serves both as an Emergency
Engine Shut-Off and as the primary Shutdown switch. This
allows the operator to shutdown the saw safely away from
moving parts.
Engine Shut-Off and as the primary Shutdown switch. This
allows the operator to shutdown the saw safely away from
moving parts.
23. Dust Collection – Provides for connection to suitable dust
collection bag or vacuum system.
24. Sash – Allows for the lowering and raising of the front
guide from the operator's position.