DISH Network 21 用户手册

If you have another DISH Network receiver installed, you can use this 
remote control in AUX mode to operate it along with your new 
receiver. When you program the remote control to operate the other 
receiver, the remote will send IR signals to that receiver, so the line of 
sight to the second receiver must be unobstructed. You can program the 
remote control to operate any other DISH Network receiver, except for:

TV2 on DISH 322, DISH Player-DVR models 522, 625, and 942, 
ViP222, ViP222k, ViP622 DVR, ViP722 DVR or ViP722k DVR

DishPlayer 7100/7200

Turn on the other receiver and open the System Information 
screen. (For help opening the System Information screen, refer to 
the user guide for the other receiver.)

Write down the TV2 address shown: 

Press and hold the AUX button until all the mode buttons light up, 
and then release the button. The AUX button flashes.

Use the NUMBER PAD on the remote control to enter a 3, 
followed by the address you wrote down in step 1.

Press POUND (#). The AUX button blinks three times.

Press RECORD to verify that the address in the remote control 
now matches the address for the receiver.

Press the SAT mode 

button.

Press the SAT mode 

button.

Press the plus (+) and 

minus (-) sides of the 
VOLUME button. 

Press the plus (+) and 

minus (-) sides of the 
VOLUME button.

Your tuner/amplifier’s 

volume changes and the 
AUX mode button lights 
instead of the TV mode 
button.

Your TV’s volume changes 

and the TV mode button 
lights instead of the AUX 
mode button.