GE GFK-0804B 用户手册

restart lowapp ARestart oddapp: ARestarts for autonumbers that do not restart in
each chapter. figure bi level 1, reset  table_big level 1, reset  chap_big level 1, reset1
Lowapp Alwbox restart evenap:A1app_big level 1, resetA figure_ap level 1, reset
table_ap level 1, reset figure level 1, reset  table level 1, reset   these restarts
oddbox reset: 1evenbox reset: 1must be in the header frame of chapter 1. a:ebx, l 1
resetA a:obx:l 1, resetA a:bigbx level 1 resetA a:ftr level 1 resetA c:ebx, l 1 reset1
c:obx:l 1, reset1 c:bigbx  level 1 reset1 c:ftr  level 1 reset1  Reminders for
autonumbers that need to be restarted manually (first instance will always be 4)
let_in level 1: A. B. C.  letter level 1:A.B.C. num level 1: 1. 2. 3. num_in level 1: 1. 2.
3. rom_in level 1: I. II. III. roman level 1: I. II. III.  steps level 1: 1. 2. 3.

This chapter is an introduction to programming the Micro PLC.

H Programming Basics
H PLC Programs

h Power Flow in a Program

H The Micro PLC Instruction Set
H Programming Devices and Formats

h Programming with the Programming Software
h Programming on a Hand-held Programmer

H Memory Types and Addresses

h Memory Map
h Non-retentive and Retentive Registers
h Reserved Registers
h Constants and Register Values in a Program

H Special Coils

h 0.1 Sec Clock (C1018)
h Start-up Scan Coil (C1019)
h Hold Output Coil (C1021)

H Programming for an Analog Expander Unit

h Analog Scaling
h Analog References
h Programming Examples