Roland TU-400 用户手册
14
8. Starting Operation
Do not allow the hands or hair to
touch the paper tube, flange, or
sheet during take-up.
touch the paper tube, flange, or
sheet during take-up.
The hands or hair may become caught.
During operation, do not enter the sensor's detection area. Doing so will result in excessive take-up and cause
printing to be interrupted.
printing to be interrupted.
When in the manual mode, make sure there is some slack in the material before attempting to perform take-up.
NOTICE
Turn on the power.
1
Data is sent from the computer and
printing on the CJ/FJ starts.
printing on the CJ/FJ starts.
3
2
Set the desired direction of take-up.
Forward
Take-up
Take-up
Backward
Take-up
Pull out the material and ensure a certain amount of slack,
as shown in the figure. Move the sheet loading lever to
secure the material in place.
as shown in the figure. Move the sheet loading lever to
secure the material in place.
3
Move the [MANUAL] switch to the [BACKWARD]
setting and take up one turn's worth of material.
After take-up, maintain slack as shown in the figure to
keep the material from being drawn taut by take-up.
setting and take up one turn's worth of material.
After take-up, maintain slack as shown in the figure to
keep the material from being drawn taut by take-up.
4
Front <---