Universal Remote Control MRF-300/RFX150 用户手册
Page 3
MRF-300 B
ASE
S
TATION
Installation
Step 1 - Set the RF ID # rotary switch on the bottom of the MRF-300 to a
VALID ID# (any address other than ID# 0). If you leave it set to ID# 0, the MRF-300
operates with some restrictions:
VALID ID# (any address other than ID# 0). If you leave it set to ID# 0, the MRF-300
operates with some restrictions:
a. Accepts RF signals from any 418MH
Z
remote control regardless of
the address set when programming the remote control.
b. Front Blaster will be OFF and all IR line outputs are set to ALL).
Step 2 - Mount or place the MRF-300 conveniently and run flashers
to each component’s front panel sensor or connect the Line Out to
a components rear panel IR Input.
to each component’s front panel sensor or connect the Line Out to
a components rear panel IR Input.
Slide off the mounting plate to reveal the RF ID# rotary switch. Use a small flat blade
screwdriver to set the RF ID# to the address you used when programming the remote
control (1-9 or A-F are valid addresses, while 0 is not a valid address).
screwdriver to set the RF ID# to the address you used when programming the remote
control (1-9 or A-F are valid addresses, while 0 is not a valid address).
MRF-300 Manual.qxd 1/14/2005 12:40 PM Page 3