Universal Electronics Polaris 用户手册

The Polaris Remote Control is preprogrammed to 
operate the cable box (converter) provided by your cable 
company, and an RCA TV. To control devices other than 
the default brands, perform the following steps; 
otherwise skip this section.
NOTE:  

If you have another brand of cable converter 
you would like to control, you’ll need to 
unlock the cable ID Lock before changing the 
converter code (see “Programming ID Lock” 
on page 14). 

1.

Turn on a device.

 NOTE:   Please read steps 2 through 4 completely 

before proceeding. Highlight or write down 
the codes and device you wish to program 
before moving on to step 2. 

3.

Use the “Manufacturer’s Codes (Códigos del 
Fabricante)” starting on page 39) to locate the 
type of device and brand name and then enter 
the first four-digit code for your device. If 
performed correctly, the selected mode key 
blinks twice. 

If the selected mode key emits a long blink, 
the entry is invalid. Repeat steps 2 through 3 
and try entering the same code again. 

5.

Repeat steps 1 through 4 for the other device 
you want the remote control to operate (either 
TV or CBL). For future reference, write down 
each working device code in the boxes on the 
following page. 

2.

On the remote control, press a device key once 
(i.e., TV or CBL); it blinks once. Then press 
and hold SETUP until the selected mode key 
blinks twice.

4.

Aim the remote control at the device (either 
TV or CBL) and press the key for that device 
once. The device should turn off. If it does 
not, repeat steps 2 through 3, trying each code 
for your brand until you find one that works. 
If it still does not respond, try searching for 
the code (see “Searching for Your Code” on 
page 13).