Xantech CC12 用户手册



2

CC12

5

0

2

3

4

5

6

1

7

Place the

on the RC68+

0

1

2

3

4

5

6

7

CODE

SUB-

GROUP

6

2

4

3

1

The RC68 Programmer

The RC68+ Programmer (available separately) contains all the commands necessary to operate the CC12.

• You will need it to program universal learning devices such as the Xantech URC-1 learning remote, the

Xantech Smart Pads, the 590 Programmable Controller, the 710 Fone Link, etc., with commands that
operate the CC12.

• NOTE: The RC68+ codes operate several other Xantech models as well, such as the RS41AV, RP41AV,

ZPR68, etc.  Therefore, only the button descriptions that apply to the operation of the CC12
(OVERLAY 'B') are listed below.  All others should be ignored.

CAUTION:  While the RC68+ will operate as a separate remote control, it is highly recommended it not
be given to the final user for the following reasons:

• Since it includes setable code groups, the user may inadvertently alter the installer configurations.

• Also, since the user will require IR commands from other brands of equipment to control the total system,

in addition to those of the CC12, all commands should be consolidated into one learning device, for ease
of use.

1. Pair OFF Command.  This button activates the IR command that

turns the internal relay of the CC12 to the OFF position (the N/C
selection).

2. Pair ON Command.  This button activates the IR command that

turns the internal relay of the CC12 to the ON position (the N/O
selection).

3. TGL (toggle) Command. The first press of this button turns the

relay ON (the N/O selection) - the second press turns it OFF (the
N/C selection).

4. MMT (momentary) Command.  Pressing this button causes the

CC12 relay to go ON (the N/O selection) but stays ON only as long
as the button is held down. When released, the relay returns to the
OFF position (the N/C selection).

5. IR Emitter Lens.

The RC68+ has 11 rows of 5 buttons each.  Each row, identified by the
numbers 0 through 7 (see Fig. 2), will execute the same set of 4
commands listed above, when selected by the CODE SUB-GROUP switch on the CC12. This is useful to
prevent mutual interaction in common IR systems when using more than one CC12, or if SR21's are used
with CC12's.

To change the CODE SUB-GROUP, simply rotate the CODE SUB-GROUP switch on the CC12 to the
number that corresponds to the desired row on the RC68+.  Remove and reapply power (after 20
seconds), then use the chosen row to execute the commands for that particular CC12.

NOTE:  No changes are needed on the RC68+!

6. Code Group Numbers.  The CC12 is also capable of being set to different basic code groups as well

as the sub-groups.

It may be necessary to change the CC12 to a  different code group if it is used in a common IR bus controlled
system with many CC12'S, SR21's, etc., to avoid mutual interaction.

.