Directed Electronics 2.2 用户手册

18

© 2008 Directed Electronics. All rights reserved.

Using the system

➤

 Arming the system

To arm the system, press the 

A U 

X

 button on the remote control.

The siren in the vehicle will “chirp” once and the parking lights will flash 
once.  If  the  power  door  locks  have  been  connected,  the  doors  will 
lock. The system will automatically check for errors when it arms. 

If errors are found when arming:
If an alarm trigger zone – such as a door, the trunk, the hood, or a 
sensor, was active at the time of arming, the system will “bypass”, or 
ignore, this trigger zone. This allows the system to continue to protect
your vehicle using the remaining trigger zones.

You are notified of this active zone immediately after arming the system. 
The siren in the vehicle will “chirp” again and the parking lights will 
flash again. The Status LED indicator in the vehicle will blink in a pattern 
to indicate the active zone number error which was found (See Table 
of Zones on page 34). 

Arming without the chirp (Silent Arm): 
Press the 

 button at the bottom of the remote once, and then press 

the 

A U 

X

 button. The system will arm without the confirmation chirp. The 

parking lights will flash once. 

➤

 While the system is armed

Fail-Safe Starter Kill

• 
The starter is disabled by the system’s Fail-Safe starter kill (if installed).