United States Pumice Company 98580 用户手册

Page 11

Item 98580 

        

If an automatic oiler is not used, add a few 

drops of Pneumatic Tool Oil to the airline 

connection before use.  Add a few drops 

more after each hour of continual use.

impORtant: Before each use, test the 

Shear on scrap material of the same weight 

and hardness as the workpiece.

1.  Mark the cutting line on the workpiece. 

2.  Hold the Shear with both hands 

safely away from Blades.

3.  Position the Shear so that the Center Blade 

is below, and the Left and Right Blades 

are above, the edge of the workpiece.

4.  Squeeze and hold the Trigger and allow 

the Blades to reach full speed. 

5.  Guide the Blades along the marked 

line of the workpiece.

6.  If the tool requires more force to accomplish 

the task, verify that the tool receives sufficient, 

unobstructed airflow (CFM) and increase the 

pressure (PSI) output of the regulator up to the 

maximum air pressure rating of this tool.

maximum air pressure rating. 

If the tool still does not have sufficient force 

at maximum pressure and sufficient airflow, 

then a larger tool may be required.

7.  When finished, to prevent accidents, turn off the 

tool, detach the air supply, safely discharge any 

residual air pressure in the tool, and release the 

throttle and/or turn the switch to its off position 

after use.  Clean external surfaces of the tool with 

clean, dry cloth, and apply a thin coat of tool oil.  

Then store the tool indoors out of children's reach.