Motorola G24 用户手册

Numeric parameter that indicates whether the EDGE 
bearer shall provide in-sequence SDU delivery or not.
0 - no
1 - yes
2 - subscribed value.
Other values are reserved.
<Maximum SDU size>: a numeric parameter (1,2,3,…) 
that indicates the maximum allowed SDU size in octets. 
If the parameter is set to '0' the subscribed value will be 
requested.

Numeric parameter (1,2,3,…) that indicates the 
maximum allowed SDU size in octets. If the parameter 
is set to '0' the subscribed value will be requested.

String parameter that indicates the target value for the 
fraction of SDUs lost or detected as erroneous. SDU 
error ratio is defined only for conforming traffic. The 
value is specified as 'mEe'. As an example a target SDU 

error ratio of 5x10

-3

 would be specified as '5E3' (e.g. 

AT+CGEQREQ=…,"5E3",…). '0E0' means subscribed 
value.

String parameter that indicates the target value for the 
undetected bit error ratio in the delivered SDUs. If no 
error detection is requested, Residual bit error ratio 
indicates the bit error ratio in the delivered SDUs. The 
value is specified as 'mEe'. As an example a target 

residual bit error ratio of 5x10

-3

 would be specified as 

'5E3' (e.g. AT+CGEQREQ=…,"5E3",…). '0E0' means 
subscribed value.

Numeric parameter that indicates whether SDUs 
detected as erroneous shall be delivered or not.
0 - no 
1 - yes
2 - no detect
3 - subscribed value

Numeric parameter (0,1,2,…) that indicates the targeted 
time between request to transfer an SDU at one SAP to 
its delivery at the other SAP, in milliseconds. If the 
parameter is set to '0' the subscribed value will be 
requested.

Numeric parameter (1,2,3,…) that specifies the relative 
importance for handling of all SDUs belonging to the 
EDGE bearer compared to the SDUs of other bearers. If 
the parameter is set to '0' the subscribed value will be 
requested.

(See +CGDCONT command).
If a value is omitted for a particular class then the value 
is considered to be unspecified.