Motorola MicroTAC 用户手册
Programming Scanning Modes
45
Overview
The characteristics that determine the way your phone
operates in the Cellular System are determined by the
Scanning Mode programmed for your phone.
operates in the Cellular System are determined by the
Scanning Mode programmed for your phone.
Reviewing / Changing Scanning Mode
Typically, the scanning mode for your phone is
programmed by your Service Provider. However, you may
review the current scanning mode and (if desired) change
it by following these procedures.
programmed by your Service Provider. However, you may
review the current scanning mode and (if desired) change
it by following these procedures.
To Review Scanning Mode
1. Press
,
. The display will show the current
active system choice.
2. Press
to exit without changing selections.
To Change Scanning Modes
1. Press
,
. The display will show the current
active system choice.
2. Repeatedly press
or
to cycle through the
scanning modes.
3. When the desired scan setting appears in the display,
press .
4. Press
to exit to normal operation.
NOTE
Constant flashing of RM, or a steadily lit NS while
within your home service area may indicate an
unintentional choice has been made. If this occurs, review
the System Type to see if the unit is operating in Standard
Mode, or if an alternate selection has been made.
unintentional choice has been made. If this occurs, review
the System Type to see if the unit is operating in Standard
Mode, or if an alternate selection has been made.
RCL
END
RCL
STO
END
MicroTAC_Book Page 45 Thursday, October 16, 1997 1:30 PM
Black spot 45.0
°
169.71 LPI