Husqvarna 115 13 82-95 用户手册

English

 –

 37

115 13 82-95 Rev.2 2009-03-23

The spark plug condition is influenced by:

•

Incorrect carburetor adjustment.

•

An incorrect fuel mixture (too much or incorrect type of 
oil).

•

A dirty air filter.

These factors cause deposits on the spark plug 
electrodes, which may result in operating problems and 
starting difficulties.

If the machine is low on power, difficult to start or runs 
poorly at idle speed: always check the spark plug first 
before taking any further action. If the spark plug is dirty, 
clean it and check that the electrode gap is 0.020 inch (0.5 
mm). The spark plug should be replaced after about a 
month in operation or earlier if necessary.

Note! Always use the recommended spark plug type! Use 
of the wrong spark plug can damage the piston/cylinder. 
Check that the spark plug is fitted with a suppressor.

Lubricate the bar tip sprocket each time you refuel. Use 
the special grease gun and a good quality bearing grease.

The clutch drum has a needle bearing on the output shaft. 
This needle bearing must be lubricated regularly (once a 
week).

When lubricating, remove the clutch cover by loosening 
the two bar nuts. Lay the saw on its side with the clutch 
drum upwards.

Lubrication involves engine oil dripping into the centre of 
the clutch drum as it rotates.

Adjustments are made by turning the screw using a 
screwdriver or combination spanner. The machine is 
supplied from the factory with the screw set to position 2. 
Turning the screw clockwise will reduce the oil flow and 
turning the screw anti-clockwise will increase the oil flow.

Recommended settings:

These recommendations apply to Husqvarna’s chain oil, 
for other chain oils increase the oil flow by one step.

Bar 13"-15": Position 1

Bar 15"-18": Position 2

Bar 18"-20": Position 3