Coleman 9271-210 用户手册

下载
页码 2
3
Raise Tent
–Assemble center shock-corded brace poles 
(longer poles).
–Insert square end of brace poles into
curved roof poles and raise tent upright.
(illus. 5, 6)
–Brace poles should attach to squeeze 
pins at bottom of tent. (illus 7)
–Assemble end (shorter) shock-corded 
brace poles.
–Insert end brace poles into end
roof assemblies. MAKE SURE when 
attaching the brace poles to the curved 
poles that the bottom of the brace pole 
naturally points down and toward the 
center of the tent. (illus. 9)
–Brace poles attach to squeeze 
pins at edge of tent. (illus. 8)
illus. 6
Shown with center brace
poles and end brace poles
in position.
Center brace pole
Grommets for
rainfly pole
End brace
pole
illus. 8 
Rainfly poles
through pole
sleeves
Rainfly pole inserts into 
grommets on tent
4
illus. 5 When attaching the brace
poles to the curved poles make
sure that the brace poles naturally
point straight down.
illus. 9 Tent shown
completely set-up.
Attach Rainfly
–Assemble rainfly poles,by interlocking 
shock-corded poles.
–Insert rainfly pole through the pole 
sleeves located at the center edges 
of the underside of rainfly. (illus. 8)
–Drape rainfly over tent frame, pole side
down. rainfly poles go over door and 
rear window and attach “S” hooks on 
rainfly into holes in brace poles. (illus. 11)
–Secure rainfly with hook & loop 
fasteners located on underside 
of fly. (illus. 9)
–Insert tip of rainfly pole into the 
grommet on the front of the tent 
and gently arch the pole until you 
can insert the opposite end in the 
other grommet.. Repeat for back 
side of tent. (illus. 6 & 9)
–Stake out rainfly ends using included 
guylines. (illus. 10)
Brace pole
Curved
poles in pole
sleeve
Brace pole
with hole 
for rainfly 
“S” hooks
illus. 10 Stake out rainfly
ends. Slide the disc up
the rope to tighten 
guyline.
illus. 7
Insert squeeze
pin into pole
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219 
1-800-835-3278  •  www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA  
Rev. 12/03
Things You Should Know
• 
Under certain conditions (cold weather, high  humidity, etc.) 
condensation will form on the inside surfaces of your tent. Condensation is caused by
water vapor from your breath, perspiration, or any wet clothing inside your tent. It is 
NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing
from your tent and by providing good ventilation through the tent.
• 
Never store tent, even for a short period of time, without drying it thoroughly and
brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate
storage bag.
• 
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER
PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
• 
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• 
Seam sealer has not been provided with your tent. We recommend seam sealing your
tent prior to camping. Seam sealer may be purchased through your local retailer or at
your local sporting goods store.
• 
Do not leave your tent set-up for weeks at a time, be aware that exposure to the
ultraviolet rays of the sun can seriously damage material and/or cause it to become
discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES 
AWAY FROM THIS TENT  FABRIC. 
This tent meets the flammability requirements
of CPAI-84.The fabric will burn if left in continuous contact with any flame source.The
application of any foreign substance to the tent fabric may render the flame-resistant
properties ineffective.