Eureka! Tents Grayback 用户手册

fig.7

fig.8

fig.1

fig.2

fig.3

fig.4

fig.6

fig.5

fig.9

fig.10

Component List:
1 Tent Body, 2 Tent Poles, 1 Carry Bag, 1 Tent Fly, 1 Stake Bag/ 
Stakes 

Unroll and unfold the tent with the floor on the ground. Remove the 
fly and set it aside. Do not stake the tent down yet. In windy 
conditions, we recommend that a narrow end should face into the 
wind and that you stake down one of its corners.

Join the shock-corded poles together. Try to prevent pole sections 
from snapping together, as this can damage the pole ends. Note: 
Make certain each insert (male end) has seated firmly into each 
plain end (female).

At the front corner of the tent 
A, slide one of the poles 
through the rod sleeve toward 
the opposite side of the tent. 
Push the pole to the opposite 
corner; 

A to B. At the other 

front tent corner 

C, repeat 

with the second pole; 

C to D. 

See fig. 1 & 2

With the poles threaded through their proper 
sleeves, start again at the front of the tent and 
insert the pin into the pole ferrule at 

A, making 

sure the buckle remains on top of the web. 
Walk to 

B and grasp the other end of the pole 

in one hand and the web loop 
in the other. Push the pole 
from 

B to A creating an arc. 

Insert the pin into the pole 
ferrule to tension the tent 
across the seam line. Repeat 
with the other pole; 

C to D. 

See fig. 3 & 4.

With the tent secure, drape the fly over the tent body. 
The fly only fits on the tent one way. Position the fly 
over the tent with the Eureka! logos over the doors. 
Reach under the fly, wrap the Velcro™ tabs about 
half way down and around each pole. See fig. 7 & 8.

REV.B 4.09  

Working your way around the tent, 
attach the four clips to the poles. 

Your tent is now free-standing, 
place it in location that has 
enough room for the fly and stake 
it down through the rings. Stake 
the opposite corners while 
applying tension to smooth the 
floor wrinkles. See fig. 5 & 6.

Connect the four corner buckles on the fly to their 
mates on the tent webs.
At the front of the tent, pull the vestibule taut and 
stake down the loop. Make sure that the vestibule is 
tight across the front of the tent. Repeat with the 
vestibule at the rear of the tent. Then stake out the two 

side loops to keep the fly out and away from the tent. 
Adjust and tighten all the buckles. See fig. 9 & 10.

Take down: Pull up stakes and open doors. Remove 
the fly. Un-clip tent from the poles. 
Pull poles out off the pins, collapse 
the poles and stow in the bag. 
Fold the tent/fly. Roll up 
both towards the door 

and stow in the carry 
bag.