Coleman 2000007832 用户手册

4010009475 (20100611)

STITCH LINE

1. All stakes must be placed in the storage bag to prevent 

damage to the fabric items placed in the carry case.

2. Make sure all components are clean and dry before 

placing in carry case.

3. Store in a clean, dry area.

t Under certain conditions (cold weather, high humidity, 

etc.) condensation will form on the inside of your shelter. 
Condensation is caused by water vapor from your breath, 
perspiration, or any wet clothing inside the shelter. It is NOT 
LEAKAGE through the shelter fabric. 

t Tree limbs, tree sap, bird droppings, or moisture steadily dripping 

off tree limbs can cause damage to the shelter fabric and its 
coating resulting in leaks or loss of flame-resistant properties.

t Never store tent, even for a short period of time, without drying it 

thoroughly and brushing off caked dirt. Do not pack stakes inside 
your tent. Use a separate storage bag.

t Stakes should be removed by pulling on the stake itself. NEVER 

PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT 
IN PROPERTY DAMAGE OR PERSONAL INJURY.

t Do not leave your tent set-up for weeks at a time. Be aware that 

exposure to ultraviolet rays from the sun can seriously damage 
material and/or cause it to become discolored.

t This product is not intended to be used during heavy rain, wind, 

hail, snow or other inclement weather. Excess water build-up 
can cause the frame system to be come unstable, and possibly 
collapse, causing injury. 

To take down the tent, follow the previous steps and 
illustrations in the reverse order:
tRemove guylines and stakes. (Fig. 10 and 9)
tLower the frame one leg pole at a time by pushing the 

lock buttons and collapsing the telescoping leg 
poles. (Fig. 6)

t Fold the arm joints located at each of the tent 

corners. (Fig. 4)

t Collapse the tent by folding the arms upward until the 

tent stands upright with the hub assembly at the top. 
(Fig. 2 and 1)

t Place the tent in the carry bag for storage.

TIP: After collapsing the tent, place it on its side, then roll 
it multiple times with pressure to reduce its size. This will 
allow the unit to slip into the carry bag.

This tent meets the flammability requirements of CPAI-84. The 
fabric may burn if left in continuous contact with any flame source. 
The application of any foreign substance to the tent fabric may 
render the flame-resistant properties ineffective.

t The tent should be taken down and placed in storage during 

windy conditions to avoid damage to product or personal injury.

t DO NOT use gas or flame sources under or near this product.

tAttach and stake out guylines. (Fig. 10)
tAdjust sliders to make guylines tight.

t Secure tent by driving stakes through the 

webbing loops sewn to the tent base. (Fig. 9)

t Keep the floor taut.

5IF$PMFNBO$PNQBOZ *ODt/PSUI)ZESBVMJDt8JDIJUB ,BOTBT64"

tXXXDPMFNBODPN

MADE IN CHINA 

© 2010 The Coleman Company, Inc. All rights reserved.

Coleman

®

, 

 , and 

 are registered trademarks of 

The Coleman Company, Inc.