Uniden 880 用户手册

or other convenient point. Then connect the black power cord to the

vehicle chassis or negative (-) battery terminal.

install 6-pin to 4-pin aDapter

The Bearcat 880 is pre-configured for Uniden’s new 6-pin wireless, noise-

cancelling technology, available in 2012. Your Bearcat 880 comes with an

adapter to connect the radio’s 6-pin microphone to a current standard

4-pin microphone.
1. Insert the 6-pin side of the adapter into the Bearcat 880 6-pin

microphone connection.

2. Plug a standard 4-pin microphone connector into the 4-pin side

of the adapter.

marine installation

Consult your dealer for information regarding marine installation. It is

important to adequately ground the system and to prevent electrolysis

between the fittings in the hull and the water.

Using yoUr BearCat 880

CB moDe

Be sure that the power source, antenna, and microphone are properly connected

before proceeding.

BasiC settings
1. Turn unit on. Set volume to a comfortable level.

2. Select channel.

3. Set noise limitations as desired (ANL/NB).

4. Adjust Squelch.

• Turn SQUELCH fully clockwise so only strong signals can get

through.

• Turn SQUELCH fully counterclockwise until you hear a hiss.

Everything gets through - noise, weak signals, and strong signals

• Turn SQUELCH back clockwise until the hiss stops. Only clearer

signals get through.

Set SQUELCH only when the radio is not receiving a strong signal.