COBY electronic TF-DVD8509 用户手册

For Customer Use:
Enter below the serial number that is located on the 
bottom of the unit. Retain this information for future 
reference.

Model No. 

TF-DVD8509

Serial No.

CAUTION:  TO  REDUCE  THE  RISK  OF  FIRE  AND  ELEC-
TRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK) 
OF  THE  UNIT.  REFER  SERVICING  ONLY  TO  QUALIFIED 
SERVICE PERSONNEL.

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert 
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure 

that may be of sufficient magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the pres-

ence of important operation and servicing instructions in the literature accompanying the 
appliance.

To prevent fire or shock hazard, do not expose this device to rain or moisture. Dangerous high voltage is present inside the 

enclosure. Do not open the cabinet.

Handling the cords on this product will expose you to lead, a chemical known to the State of California to cause cancer, and 

birth defects or other reproductive harm. Wash hands after handling.

This Digital Video Disc player employs a laser system. To prevent direct exposure to the laser beam, do not try to open the 

enclosure or defeat the safety interlocks. When open and the interlocks are defeated, visible laser radiation is present.

To prevent electric shock, match wide blade of plug to wide slot of outlet and fully insert.

Use of controls, adjustments, or performance of procedures other than those specified herein may result in hazardous radiation 

exposure. DO NOT STARE INTO THE BEAM.

NOTICE:

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property 

rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other 

limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

FCC Statement:this device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions:

(1) This device may not cause harmful interference, and(2) This device must accept any interference 

received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for Class B digital devic-
es, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can radi-

ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following measures:

-  Reorient  or  relocate  the  receiving  antenna.-  Increase  the  separation  between  the  equipment  and 

receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.- Consult the dealer or an experienced radio/TV technician for help. 

Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC 
rules.