Linksys DES-3028/DES-3028P/DES-3052/DES-3052P 用户手册

DES-3028 DES-3028P DES-3052 DES-3052P  Layer 2 Fast Ethernet Switch CLI Reference Manual 

The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the 
following table. 

config ipif  

[System] [{ipaddress <network_address> | vlan <vlan_name 32> 
| state [enable | disable]} | bootp | dhcp] 

show ipif 

 

enable autoconfig* 

 

Each command is listed, in detail, in the following sections. 

*See Switch Utility Commands for descriptions of all autoconfig commands. 

Purpose 

Used to configure the System IP interface. 

Syntax 

Description 

This command is used to configure the System IP interface on the 
Switch. 

Parameters 

System - Enter System. 
ipaddress <network_address> 

− IP address and netmask of the IP 

interface to be created. Users can specify the address and mask 
information using the traditional format (for example, 
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).   
<vlan_name 32> 

− The name of the VLAN corresponding to the 

System IP interface. 
state [enable | disable] 

− Allows users to enable or disable the IP 

interface. 
bootp 

− Allows the selection of the BOOTP protocol for the 

assignment of an IP address to the Switch’s System IP interface. 
dhcp 

− Allows the selection of the DHCP protocol for the assignment 

of an IP address to the Switch’s System IP interface. If users are 
using the autoconfig feature, the Switch becomes a DHCP client 
automatically so it is not necessary to change the ipif settings. 

Restrictions Only 

administrator-level users can issue this command. 

Example usage: 

To configure the IP interface System:   

 

 

118