Linksys DES-3028/DES-3028P/DES-3052/DES-3052P 用户手册

DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual

ARP C

OMMANDS

The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.

Command Parameters

create arpentry

config arpentry

delete arpentry

{[<ipaddr> | all]}

show arpentry

{ipif [System] | ipaddress <ipaddr> | static}

config arp_aging time <value 0-65535>

clear arptable

Each command is listed, in detail, in the following sections.

create arpentry

Purpose

Used to make a static entry into the ARP table.

Syntax

create arpentry <ipaddr> <macaddr>

Description

This command is used to enter an IP address and the
corresponding MAC address into the Switch’s ARP table.

Parameters

<ipaddr>

− The IP address of the end node or station.

<macaddr>

− The MAC address corresponding to the IP address

above.

Restrictions

Only administrator-level users can issue this command. The Switch
supports up to 255 static ARP entries.

Example Usage:

To create a static arp entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:

DES-3028P:4#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36

Success.

DES-3028P:4#

config arpentry

Used to configure a static entry in the ARP table.

Syntax

config arpentry <ipaddr> <macaddr>