Linksys DES-3028/DES-3028P/DES-3052/DES-3052P 用户手册

DES-3028 DES-3028P DES-3052 DES-3052P  Layer 2 Fast Ethernet Switch CLI Reference Manual 

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the 
following table. 

show packet ports 

<portlist> 

show error ports 

<portlist> 

show utilization 

[cpu | ports {<portlist>}] 

clear counters 

ports <portlist> 

clear log 

 

show log 

index <value_list X-Y> 

enable syslog 

 

disable syslog 

 

show syslog 

 

create syslog host 

<index 1-4> ipaddress <ipaddr> {severity [informational | warning | 
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | 
local7] | udp_port <udp_port_number>|  state [enable | disable] 

config syslog host  

[all | <index 1-4>] {severity [informational | warning | all] | facility 
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | 
udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable 
| disable]} 

delete syslog host 

[<index 1-4> | all] 

show syslog host 

<index 1-4> 

config log_save_timing 

[time_interval <min 1-65535> | on_demand | log_trigger] 

show log_save_timing 

 

Each command is listed, in detail, in the following sections. 

Purpose 

Used to display statistics about the packets sent and received by the 
Switch. 

Syntax 

Description 

This command is used to display statistics about packets sent and 
received by ports specified in the <portlist>. 

Parameters 

<portlist> 

− Specifies a port or range of ports to be displayed.  

Restrictions None. 

Example usage: 

To display the packets analysis for port 7 of module 2: 

 

57