Roland AR-200 用户手册

Appendices

Control I/O Connector specifications

fig.contB

fig.continput

* Control Input and DC Input Terminal (CONT A) “1,2” are

connected in parallel with Control I/O Connector (CONT B)
“1,2.”

* When using Program Playback on a PC card created by the

AR-3000, use connectors 1 (INC), 3 (DEC), 5
(EXCHANGE), 9 (START), and 10 (STOP)

* Do not make any connection to NC pins, since this will cause

faulty operation.

DC power supply

• Power can be supplied to the AR-200 from an external

power supply unit (DC power supply) as well as from
the AC adaptor.

• To supply power from an external power supply unit

(DC power), use the Control Input and DC Input
Terminal (CONT A) or the Control I/O Connector
(CONT B) DC IN and GND pins.

Power supply specifications:

DC +9—24 V, 900 mA

• The DC OUT pin of the Control I/O Connector (CONT

B) can be used as power supply for a sensor, etc.

* Never short a power supply pin (21, 24, 25) to the GND pin,

since this will damage the unit.

* When using the DC OUT, be careful not to exceed the

maximum rating (100 mA).

For reasons of safety, do not connect the DC IN + pin of the
Control Input and DC Input Terminal (CONT A) to metal
parts such as the chassis or the Control I/O Connector
(CONT B).

Do not supply electrical power simultaneously to multiple
connectors or terminals; doing so may result in damage to
the unit.

Port No.

Signal Name

1
2
3
4
5
6
7
8
9

10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25

1/INC
2
3/DEC
4
5/EXCHANGE
6
7
8
9/START
STOP
GND
GND
BUSY OUT
NC
CONT OUT
GND
BUSY OUT
CONT OUT
NC
NC
DC OUT (+5 V, Max :100 mA)
GND
GND
DC IN (+9 – 24 V, 900 mA)
DC IN (+9 – 24 V, 900 mA)

Control Input

Control Output

AR-200_e.book 57 ページ２００３年７月１４日　月曜日　午後１時１１分