Roland AR-3000R 用户手册
95
Controlling the AR-3000R from an External Device
Applications
Playback Trigger Settings (Level/Edge)
Use combinations of playback trigger (Level/Edge) ON and
OFF to achieve the four types of playback shown below.
OFF to achieve the four types of playback shown below.
• Level: OFF; Edge: OFF
• Level: ON; Edge: OFF
• Level: OFF; Edge: ON
• Level: ON; Edge: ON
Operational Specifications of Binary Playback
→
Procedure for Setting the Playback Triggers
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “5.4 Binary Play,” then
press the dial.
press the dial.
3.
Turn the SELECT dial to choose the playback trigger
Level (OFF or ON), then press the ENTER button.
Level (OFF or ON), then press the ENTER button.
fig.14-g11e
4.
Turn the SELECT dial to choose the playback trigger
Edge (OFF or ON), then press the dial.
Edge (OFF or ON), then press the dial.
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
choose “NO,” then press the ENTER button.
Once the settings have been made successfully, you’re
returned to the setting item selection screen.
returned to the setting item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
screen.
* While making the settings, you can go back to the previous
entry position (highlighted) by using the PAUSE (BACK)
button.
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded
To Specify Phrases With Binary
Signals
Signals
Example:
Specifying Phrase A0015 (Card: A, Phrase #: 0015)
1.
Convert the phrase number to a binary signal number.
”0” (OFF)
”1” (ON)
The phrase number “0015” becomes the binary signal
“0000001111.”
“0000001111.”
2.
Select Card A or B with and ON or OFF control signal to
Port No. 11.
Port No. 11.
Card A: “0” (OFF)
Card B: “1” (ON)
* If there is no connection to Port No. 11, this is the same as
“OFF,” and Card A is selected.
With the above steps, Phrase No. A0015 is converted to:
fig.14-30e
• Note that the direction of the phrase numbers (binary)
and port numbers are reversed.
• While you can select phrases from Card A as well as
Card B, note that playback will not work properly if the
card inserted when the phrase was registered is not
inserted at the time of playback (if the phrase is not
saved, the playback signal is disregarded).
card inserted when the phrase was registered is not
inserted at the time of playback (if the phrase is not
saved, the playback signal is disregarded).
• Input of binary specifications should be completed in no
more than 50 milliseconds.
Port No.
→ 1 2 3 4 5 6 7 8 9 10
Phrase No. (Binary)
Card
Input signal
→ 1 1 1 1 0 0 0 0 0 0
AR-3000R_e.book 95 ページ ２０１０年３月１８日 木曜日 午後２時６分