Roland R-88 用户手册

Overview

Slide this switch in the direction of the arrow to turn the power on/

When the power is on, setting the [HOLD] switch in the ON position 

will disable operation of the knobs, buttons, touch panel, and 

master level. Disabling these controls will help prevent unintended 

operation.
You can specify which controls to disable by using <SYSTEM 

SETUP>Ú<HOLD> (p. 66).

This mic allows you to break into the input audio and record 

comments such as credits or take numbers (p. 50).

This switch turns on the slate mic or outputs a slate tone (p. 50). If 

you slide the switch to the “MIC” position and hold it there for two 

seconds, the slate mic will turn on. If you slide the switch to the 

“TONE” position and hold it there for two seconds, a slate tone will 

be output.

This touch panel shows various information for the R-88, and also 

allows you to make settings and perform operations (p. 10).

This button stops playback or recording.

Press this button to start playback, or to pause playback or 

recording.

This button starts recording. During recording, the indicator will 

light. If you pause during recording, the indicator will blink.

Press this button to move to the beginning of the project, or to 

select the previous project. By holding down this button, you can 

rewind through the project. You can do this during playback or 

while stopped. When making various settings on the R-88, this 

button decreases the value of the selected parameter.

Press this button to select the next project. By holding down 

this button, you can fast-forward through the project. You can 

do this during playback or while stopped. When making various 

settings on the R-88, this button increases the value of the selected 

parameter.

If you press both the [

] (−) button and the [

] (+) button, 

the selected value will return to its default setting.

This button lets you make various settings for the R-88, such as 

recording/playback settings and specifying the date and time (p. 12). 

If the home screen is not displayed, this button takes you back to 

the home screen.

You can connect headphones here (p. 32).

These knobs adjust the input levels from the XLR input jacks 

(1/L–8/R) located on the right side panel (p. 31). The inner knob 

adjusts LEVEL, and the outer ring adjusts SENS.
The [LEVEL] knobs can be switched between two functions: input 

level setting or mixer fader (Level Knob Mode p. 43).
The PK (PEAK) indicator at the right of each knob will light when the 

input volume is excessive.
You can change the level at which the PK indicator will light 

(SYSTEM SETUP–PEAK INDICATOR p. 66).

This knob adjusts the output volume of the mixer. Press this knob to 

access the mixer edit screen (p. 43).

This knob adjusts the volume of the headphones and speakers. 

Press this knob to access the monitor setting screen (Headphone 

setting/PFL /REALTIME ANALYZER).