Roland R-88 用户手册

The R-88 will not be recognized by your computer if you connect it when the “MENU” screen is displayed, or during 

playback or recording. Please disconnect the USB cable, and try again.

When using Windows and if Explorer or any other software referencing the SD memory card is open when you attempt 

to close the USB connection between the R-88 and your computer, the error message “An error occurred while removing 

USB mass storage device — Unable to close device ‘unspecified volume.’  Please execute Stop Device again later.” will 

appear, and you will be unable to disconnect the R-88. Close all software or windows that are referencing the SD memory 

card. Then execute “Safely Remove Hardware” once again.

The USB flash drive connected in the R-88 cannot be viewed from the computer.

–

Please refer to the README for the driver, which can be found on the Roland web site.

Make sure that the AC adaptor or an external power supply is correctly connected. If you’re using batteries, make sure that 

the battery case is correctly installed, and that the batteries are oriented correctly, without any batteries out of place. It 

may be that the batteries have run low; install fresh batteries.

Check whether the [HOLD] switch is off. If it is on, the panel [POWER] switch will be inoperable.

The power will not turn on if the external power supply voltage is too high. The R-88 is compatible with 9–16 V.

If the R-88’s power can’t be switched on even though there’s no problem with the AC adaptor or batteries, it may have 

malfunctioned. Please contact nearest Roland Service Center as listed on the “Information” sheet.

–

The display will be dimmed if no operation is performed during the specified Display Timer interval.

When you reset the R-88 to its factory settings, all settings made using the “MENU” screen or the like will return to their 

original values. Please make the desired settings again.

p. 12, p. 65

If the R-88’s power is turned off without using its power switch (e.g., by a battery failure or disconnected AC adaptor), the 

settings you made will return to their original values. Please make the desired settings again.

p. 12, p. 65

The characters that are not “Available characters” are not displayed properly. In addition, there are cases when RENAME 

will not be performed correctly.

p. 35, p. 54

Depending on the AUTO OFF setting, power will turn off automatically if no operation is performed for a specified length 

of time.

p. 25, p. 66

Check to make sure that the setting for the end voltage (external) is appropriate.
Check to make sure that the setting for the type of batteries (alkaline, rechargeable Ni-MH batteries) to be used is correct.

p. 23, p. 66

If you’re using batteries or external source, power will turn off when the batteries run low. Please install fresh batteries.

If the AC adaptor or external power source is connected, or if batteries are installed, the internal clock will obtain its power 

from those sources. If several days pass with the batteries removed and the AC adaptor disconnected, the internal clock 

will return to its default setting. When you turn on the power in this state, the message “Clock is Initialized” will appear. If 

this message appears, please reset the date and time.

Carry out adjustment of the panel.

Check to make sure that the External power supply select switch (p. 7) is set to “ADAPTOR.”

Refer to “Using a Footswitch to Remotely Control Recording or Playback,” and verify that the connection is correct. Also 

verify that the mode and polarity switches are set correctly. The FS-5L cannot be used.