VDO Dayton CD 2737 B 用户手册

25

Eng

lish

It is possible to customize your headunit settings to your personal preferences via the SAM. To navi-

gate the SAM, here are the steps:

Short-press the 

SAM

AST

 button to enter the SAM.

Short-press   

or 

 button to select the next SAM menu item; or short-press the   

or 

 but-

ton to select the previous SAM menu item.

Turn the knob clockwise or counter-clockwise to choose the desired option.

Long-press the 

SAM

AST

 button to exit the SAM.

Note: The headunit will automatically exit SAM after 6 seconds of inaction.

TAVOL

[1 to 26]

Select the volume level of Traffic Announcement, News bulletins 

and Alarm messages.

START

[1 to 26]

Limit the starting volume when the headunit is turned on (to pre-

vent sudden loud surprise to the driver especially)

If the last-volume (before the headunit is turned off) is higher 

than the starting volume or muted, then after turning on, the 

turn-on volume is limited at the starting volume

If the last-volume is lower than the starting volume (except 

muted), the turn-on volume will be at the same level as the 

last-volume





CD LEVEL

[-2, -1, 0, +1, +2] Select the Compact Disc volume offset relative to the tuner volume

CA LEVEL

[-2, -1, 0, +1, +2] Select the Compressed Audio (MP3 or WMA) volume offset relative 

to the tuner volume

AUX LEVEL

[-2, -1, 0, +1, +2] Select the Auxiliary volume offset relative to the tuner volume

BT LEVEL

[-2, -1, 0, +1, +2] Select the Bluetooth volume offset relative to the tuner volume

BEEP

[OFF, ON]

Activate / Deactivate the confirmation beep tone

SDVC

[OFF, 1, 2]

Select the Speed Dependent Volume Control (SDVC) compensa-

tion level (only when pin A1 is connected and calibrated; please 

refer to the ‚INSTALLATION‘ page)

Level 1 gives a smaller increase (in volume) while level 2 gives 

a greater increase (in volume) with respect to the vehicle’s 

speed



SWRC

[OFF, ON]

Activate / Deactivate the steering wheel remote control

TEL MUTE

[OFF, LO, HI]

Select the logic level of your connected hands-free car kit (HFK) 

mute cable

Select ‘TELM OFF’ if no HFK is connected

Select ‘TELM LO’ if the incoming HFK mute signal is at 0V

Select ‘TELM HI’ if the incoming HFK mute signal is at 12V

Please refer to the instruction manual of your purchased HFK.







CLOCK

[OFF, RDS, 

MAN]

Select ‚CLOCK RDS‘ to activate the RDS clock or ‚CLOCK MAN‘ to 

set the clock manually.

Note: Selecting ‚CLOCK OFF‘ will disable the clock display when 

the headunit is in stand-by / off mode; hence, it will help prolong 

your battery.

CLOCK SET 

(available 

when 'CLOCK 

MAN' is se-

lected)

[12H hh:mm,
24H HH:MM]

If ‚CLOCK MAN‘ is selected, this menu item is available for cus-

tomization.

Short-press 

 

or 

 button to select the 12H/24H-digit, 

hour-digit or minute-digit

Rotate the knob to adjust the selected digits











