ONKYO ND-S1 用户手册

Prepare the adapter that came with your iPod.

1. Gently push down and slide open the dock

cover on the ND-S1.

2. Insert the adapter supplied with your iPod,

then push your iPod firmly onto the
ND-S1’s dock connector.

Notes:
• If you use a case with your iPod, always

remove it before you insert it. Otherwise, it
may not connect properly and a malfunction
may occur.

• Do not insert your iPod into the ND-S1 with-

out the adapter that came with it, as it may
put unnecessary strain on the iPod or
ND-S1’s dock connector, causing permanent
damage.

When you insert your iPod, the ND-S1 works as
follows depending on the status of your iPod.
• iPod not playing:

The ND-S1 starts charging your iPod and the
STANDBY indicator flashes slowly.

• iPod playing:

The ND-S1 turns on, the [iPod] indicator
lights up blue, and your iPod continues play-
ing.

Notes:
• If the [iPod] indicator does not light up after

you’ve inserted your iPod, this means that
your iPod is not properly seated on the dock
connector. Make sure your iPod is seated
properly on the dock connector.

• To prevent dock connector damage, don’t

twist your iPod when inserting or removing
it, and be careful not to knock your iPod
while it’s inserted.

• Don’t use your iPod with any other accesso-

ries, such as FM transmitters and micro-
phones, because they may cause a
malfunction.

■ Removing the iPod Adapter
To remove the iPod adapter from the ND-S1,
insert a small flathead screwdriver into the slot,
and lift it out, as shown below.

Inserting Your iPod into the ND-S1

ON/ST

ANDB

ANDBY

iPod

SYNC/

UNSYNC

od TRANSPOR