COBY electronic CX-CD241 产品宣传页

.3.

.1.

.4.

.5.

Handle

CD Door

Headphone 

Jack

Function Selector

REPEAT

PROGRAM

LED Display

Rotary Antenna

Band Selector

PREVIOUS

NEXT

PLAY/PAUSE

STOP

Handle discs by their outer edges and /or the center spindle holes to prevent 

fingerprints and scratches.

Do not bend or press the disc. Do not expose the disc to direct sunlight or heating

sources.

To remove stains or fingerprints from the surface of a disc, use a soft, lint-free, 

and dry cloth. Wipe in straight movements from the center of the disc to the 

outside. Do not use any chemical products, as they can damage the disc.

 Do not write on or attach labels to the surface of the disc.

 To minimize exposure to dust and dirt. Replace discs in their cases after use. 

 Store each disc in its case, out of direct sunlight, high temperature and humidity.

  

Should your player develop a problem, please check below before requesting service.

* Check if the power cord has been properly connected to 

    the power outlet.

* Be sure to select a sound source. 

    (CD, AM/FM etc.)

* Unplug the main unit, and then 

    reconnect it. This allows the unit to reset itself after a 

    power surge or power interruption.

 

* Increase the volume.

* Disconnect any headphones.

* No disc. Load a disc.

* Disc has been loaded upside down. Place the disc with 

   the label side up.

* Disc is damaged or dirty. Clean the disc or try another 

   one.

* Moisture may be condensed inside the player. Remove 

   the disc and leave the unit power on for one or two 

   hours.

* Disc is incorrect type for the player.

 

* You may be in an area of weak signal coverage.

System does not 

function at all

No sound

CD does 

not play

Radio does 

not work

. The lightning flash  with arrowhead symbol within an equilateral triangle is intended

  to alert the user to the presence of uninsulated "dangerous voltage" within the 

  product's enclosure that may be of sufficient magnitude to constitute risk of electric 

  shock to persons. 

. The exclamation point within an equilateral triangle is intended to alert the user to the

  presence of important operating and maintenance (servicing) instructions in the 

  literature accompanying the product.

CAUTION

RISK OF ELECTRIC SHOCK

           DO NOT OPEN

          WARNING: SHOCK HAZARD-DO NOT OPEN 

AVIS: RISOUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B 

                           digital device. Pursuant with the FCC Rules, Part15. These limits are designed to 

                           provide reasonable protection against harmful interference in a residential 

                           installation.

                           This equipment generates, uses and can radiate radio frequency energy. And if 

                           not installed and used in accordance with the instruction may cause harmful 

                           interference to radio communication.

The CD mechanism and the sensitive circuitry may cause interference to a radio tuner nearby. 

Do not operate this unit while operating other radio devices.

DANGER    This product utilizes invisible laser radiation.

                     Avoid direct exposure to the beam.

CAUSION   Use of controls, adjustments or procedures not listed in this manual may result in 

                     hazardous radiation exposure.

Only compact discs identified with this mark can be used with 

this player.  

Always operate the product from a power supply of the same voltage, frequency and rating as 

indicated on the product identification plate.

Do not operate product with a damaged cord or plug.

Never install the unit where there are heat sources such as radiators, heat registers, stoves, direct 

sunlight, excessive dust or where there is mechanical vibration or shock.

Switch off and unplug from AC outlet when not in use.

                

 

 

 

Portable CD Player with AM/FM Stereo Tuner

Please read this manual before connection and use.

                                                                                                                                                     

Page

SAFETY INFORMATION
IMPORTANT SAFEGUARDS        
TABLE OF CONTENTS

INDEX TO THE PARTS AND CONTROLS.................................................................................1
POWER SUPPLY/CONNECTING TO A HEADPHONE.............................................................2 

CD OPERATION/RADIO OPERATION.......................................................................................3

CARES OF DISC/SPECIFICATION........................................................................................... ..4

TROUBLE SHOOTING.................................................................................................................5

 

RANDOM

Frequency Dial

Tuning Control

Volume Control

FM ST.

REPEAT

POWER

PLAY

AC Socket

1. Press the PLAY/PAUSE button once to start playing. The current playing track number 

    appears on the LED panel. The "PLAY" LED indicator is lit during playback.

2. Press the PLAY/PAUSE button twice to stop playing temporarily during playback. 

    The current track number is flashing while pausing.

3. Press the PLAY/PAUSE button again to resume normal playback.

4. Press the STOP button to stop playing.

NOTE: To remove disc from CD player, always press STOP and wait for complete stop. 

1. Press the REPEAT button once to repeat playing the current track only, and the 

    REPEAT LED keeps ON.

2. Press the REPEAT button twice to repeat all tracks, and the REPEAT LED will be 

    flashing.

3. Press the REPEAT button once more to quit the REPEAT mode.

1. To go back to the beginning of current track, press the       button once.

2. To go back to the previous tracks, press the       button repeatedly.

3. To go to the next track, press the       button once or repeatedly to play your desired track.

RANDOM PLAY

1. Press the RANDOM button once to start playing the disc in a random order. 

The segments of the "        " on the LED window will also be lit in a random order.

2. To cancel the random play, press the RANDOM button again.

1. Press the PROGRAM button at stop mode. The "PLAY" LED will be flashing.

2. Press the        or       button to select the desired track number, and then press PROGRAM 

    to confirm.

3. Repeat step 2 to set up to 15 tracks. (The programmed # shown on LED is from "1" to 

    "9" and "A" to "F"). 

4. Press the PLAY/PAUSE button to start playing the programmed tracks.

5. To cancel the program play, press the STOP button.

1. Slide the Function Selector switch to radio.

2. Select AM, FM or FM ST by sliding the Band Selector switch to corresponding position.

    FM ST is for FM stereo reception. The "FM ST" LED indicator will be lit as receiving a 

    FM radio station.

3. Tune the desired station by turning the Tuning Control.

4. Adjust the volume with Volume Control as desired.

5. Extend Telescopic Antenna and adjust the direction and angle to obtain the optimum 

    reception.

6. Set the Function Switch to the OFF position to stop radio.

Power Supply: 110V~60Hz/220V~50Hz dual voltage 

Applicable disc: CD/CD-R

Power Consumption:  4.2W 

Output Power: 1W x2

Speaker:  8 OHM

Dimensions: 210(L) x143.5 (H) x220 (W) mm (main unit)

Weight: 1650g (main unit)

Frequency Range:  AM: 530KHz - 1700KHz

                               FM: 88MHz - 108MHz

Laser Wavelength: 760 ~ 800 nm

Tracking Method: 3-spot error detection/3.86 mm lens

Slide the Function Selector to the CD position and insert a CD disc.

4. To fast backward/fast forward through the disc, press and hold the                button.

/

.2.

Before connecting the AC power cord, please make sure to select the proper power 

supply between 110V and 220V with the Power Selector on the bottom of the unit.

Insert one end of the AC power cord into the AC socket on the rear of the unit and 

the other end into a standard wall socket.

Insert 6 x "C" size batteries (not included) in the battery compartment on the bottom 

of the unit by matching the polarities.

The unit will not operate on battery power when the AC power cord is plugged into 

the AC socket.

Replace batteries when the power indicator dims, the volume decreases or the sound 

distorts.

Use batteries of high quality and check them regularly. Alkaline batteries are 

recommended.

Do not mix new batteries with old or used batteries.

Use only batteries of the same brand and type.

Batteries should not be left in the unit if they are exhausted or if the unit is not to be 

used for a long period of time as they may leak and damage the unit. Battery leakage 

is not covered under the warranty.

You can use headphones with 3.5mm diameter stereo plug and an impedance of 32 

Ohms. When the headphones are connected, the speakers are disconnected auto-

matically.

Set the VOLUME to a low level before using headphones and gradually adjust the 

volume control to the comfortable listening level.

Do not play the VOLUME too loud for extended periods of time to avoid any damage 

to your hearing.

Power Selector

 (110V/220V)

Battery 

Compartment