Whirlpool W10388779A-SP 用户手册

This dryer is suitable for mobile home installations.  

The installation must conform to the Manufactured  

Home Construction and Safety Standard, Title 24 CFR,  

Part 3280 (formerly the Federal Standard for Mobile home 

construction and Safety, Title 24, HUD Part 280) or Standard 

CAN/CSA-Z240 MH.

Metal exhaust system hardware, available for purchase  

 

■

from your dealer. For further information, see “Assistance  

or Service” section in your “Use and Care Guide”.

Special provisions must be made in mobile homes to  

 

■

introduce outside air into dryer. Openings (such as a  

nearby window) should be at least twice as large as  

dryer exhaust opening.

Mobile Home Installation Hold-down Kit Part Number 

 

■

346764 is available to order. For further information, see  

“Assistance or Service” section in your “Use and Care 

Guide”.

To contact a qualified electrical installer.

 

■

To be sure that the electrical connection is adequate and in 

 

■

conformance with Canadian Electrical Code, C22.1-latest 

edition and all local codes. A copy of above codes standard 

may be obtained from: Canadian Standards Association,  

178 Rexdale Blvd., Toronto, ON M9W 1R3 CANADA.

To supply the required 4 wire, single phase, 120/240 volt,  

 

■

60 Hz, AC only electrical supply on a separate 30-amp 

circuit, fused on both sides of the line.  A time-delay fuse or 

circuit breaker is recommended. Connect to an individual 

branch circuit. 

This dryer is equipped with a CSA International Certified 

 

■

Power Cord intended to be plugged into a standard 14-30R 

wall receptacle. The cord is 5 ft. (1.52 m) long. Be sure wall 

receptacle is within reach of dryer’s final location.

If using a replacement power supply cord, it is recommended that 

you use Power Supply Cord Replacement Part Number 9831317.

For further information, please reference service numbers located 

in “Assistance or Service” section of your “Use and Care Guide”.

All dimensions show recommended spacing allowed, with tested 

spacing of 0" (0 mm) clearance on sides and rear. 

Additional spacing should be considered for ease of 

 

■

installation and servicing.

Additional clearances might be required for wall, door, and 

 

■

floor moldings.

Additional spacing should be considered on all sides of the 

 

■

dryer to reduce noise transfer.

For closet installation, with a door, minimum ventilation 

 

■

openings in the top and bottom of the door are required. 

Louvered doors with equivalent ventilitation openings are 

acceptable.

Companion appliance spacing should also be considered.

 

■