Whirlpool W10097001A-SP 用户手册
16
Reverse Door Swing (optional)
If your door is the 29" large Side-Swing Door,
follow steps 1-6.
If your door is the 29" Super Wide Side-Swing Door,
follow steps 1-13.
noTE: Magnetized screw driver is helpful.
large Side-Swing Door
Place towel on dryer
1.
Place towel on top of dryer to avoid damaging the surface.
Lift door until top screws in cabinet are in large part of hinge
slot. Pull door forward off screws. Set door on top of dryer.
Remove top screws from dryer cabinet.
lift door off top screws
3.
Use a small, flat-blade screwdriver to gently remove 4 hinge
hole plugs on left side of dryer cabinet. Insert plugs into hinge
holes on opposite side of dryer cabinet.
Remove and transfer hinge
hole plugs
4.
Remove bottom screws
2.
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
q
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.
If you do not feel heat, turn off dryer, and check the
following:
There may be 2 household fuses or circuit breakers for
■
the dryer. Check that both fuses are intact and tight, or
that both circuit breakers have not tripped. If there is still
no heat, contact a qualified technician.
noTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.