Whirlpool W10164752A 用户手册

Follow the “Installation Instructions” to locate, level and connect 
the dryer.

The dryer light automatically turns on inside the dryer drum when 
you open the door.

1. Unplug dryer or disconnect power.

2. Open the dryer door. Locate the light bulb cover on the back 

wall of the dryer. Remove the screw located in the lower right 
corner of the cover. Remove the cover.

3. Turn bulb counterclockwise. Replace the bulb with a 10-watt 

appliance bulb only. Replace the cover and secure with the 
screw.

4. Plug in dryer or reconnect power.

■

Has a household fuse blown, or circuit breaker tripped? 
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Was a regular fuse used? 
Use a time-delay fuse.

■

■

Was the Start button firmly pressed? 
Large loads may require pressing and holding the Start 
button for 2-5 seconds.

■

Has a household fuse blown, or has a circuit breaker 
tripped?
The drum may be turning, but you may not have heat. 
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

■

Has the dryer had a period of non-use? 
If the dryer hasn’t been used for a while, there may be a 
thumping sound during the first few minutes of operation. 

■

Is a coin, button or paper clip caught between the drum 
and front or rear of the dryer? 
Check the front and rear edges of the drum for small objects. 
Clean out pockets before laundering.

■

Is it a gas dryer?
The gas valve clicking is a normal operating sound.

■

Are the four legs installed, and is the dryer level front to 
back and side to side? 
The dryer may vibrate if not properly installed. See the 
Installation Instructions.

■

Is the clothing knotted or balled up? 
When balled up, the load will bounce, causing the dryer to 
vibrate. Separate the load items and restart the dryer.

■

“PF” (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START to restart the dryer.

■

“F” Variable (F1, F2, F20, etc.) service codes:
Call for service.

■

Is the lint screen clogged with lint? 
Lint screen should be cleaned before each load.

■

Is the exhaust vent or outside exhaust hood clogged with 
lint, restricting air movement? 
Run the dryer for 5-10 minutes. Hold your hand under the 
outside exhaust hood to check air movement. If you do not