Whirlpool W10240585C-SP 用户手册

The dryer must be connected to the cold water faucet using the 

new inlet hoses. Do not use old hoses.

Turn cold water faucet off and remove washer inlet hose.

Check and see if rubber washer is in the “Y” connector. 

Remove old rubber washer from inlet hose and replace with 

new rubber washer provided. 

Remove red cap from gas pipe. Using a wrench to tighten, 

connect gas supply to dryer. Use pipe-joint compound  

on threads of all non-flared male fittings. If flexible metal  

tubing is used, be sure there are no kinks.

NOTE: For LP gas connections, you must use pipe-joint 

compound resistant to action of LP gas. Do not use  

TEFLON

®†

 tape.

A combination of pipe fittings must be used to connect dryer 

to existing gas line. A recommended connection is shown. 

Your connection may be different, according to supply line 

type, size, and location.

A. 3/8" flexible gas connector

B. 3/8" dryer pipe 

C. 3/8" to 3/8" pipe elbow

D. 3/8" pipe-to-flare adapter fitting

Open shut-off valve in supply line; valve is open when handle 

is parallel to gas pipe. Then, test all connections by brushing 

on an approved noncorrosive leak-detection solution. 

Bubbles will show a leak. Correct any leaks found.

†®TEFLON is a registered trademark of E.I. Dupont De Nemours and Company.

Non-flared  

male fitting

Flared  

male fitting

 Open valve 

Closed valve

diamond

marking

Examine leveling legs, find diamond marking. Screw legs into  

leg holes by hand, use a wrench to finish turning legs until 

diamond marking is no longer visible.

Now stand the dryer on its feet. Slide the dryer until it is 

close to its final location. Leave enough room for electrical 

connection and to connect the exhaust vent.