Whirlpool W10164159B 用户手册

8. Using pliers, tighten the couplings with an additional two-thirds 

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

9. Attach other end of long hose to fill valve at bottom of dryer back 

panel. Screw on coupling by hand until it is seated on fill valve 
connector. 

10. Using pliers, tighten the coupling with an additional two-thirds 

turn.

NOTE: Do not overtighten. Damage to the coupling can result.

11. Check that the water faucets are on.

12. Check for leaks around “Y” connector, faucet, and hoses.

Check the levelness of the dryer by first placing a level on the top of 
the dryer near the console.  

Then, by placing a level in the crease on the side of the dryer 
between the top of the dryer and the dryer cabinet, check the 
levelness from front to back.

If the dryer is not level, prop up the dryer using a wood block. Use a 
wrench to adjust the legs up or down and check again for levelness.

You can change your door swing from a right-side opening to a left-
side opening, if desired. 

1. Place a towel or soft cloth on top of the dryer or work space to 

avoid damaging the surface.

1. Open the dryer door.

2. Remove the bottom screw from each of the 2 hinges that attach 

the dryer door to the front panel of the dryer.

3. Loosen the top screw from each of the 2 hinges in Step 2.

4. Remove the dryer door and the hinges by lifting upward on the 

door. Lay the door on a flat, protected surface, with the inside of 
the door facing up. Remove remaining 2 loose screws from dryer 
front panel.