Whirlpool W10164159B 用户手册

Your Dryness Level settings can be adjusted to adapt to different 
installations, environmental conditions or personal preference. There 
are 3 drying settings: 1 (factory preset dryness level), 2 (slightly dryer 
clothes, approximately 15% more drying time), and 3 (much dryer 
clothes, approximately 30% more drying time). 

1. The Dryness Level settings cannot be changed while the dryer is 

running.

2. Press and hold the DRYNESS button for 5 seconds. The dryer will 

beep, and “CF” will be displayed for 1 second followed by the 
current drying setting.

3. To select a new drying setting, press the DRYNESS button again 

until the desired drying setting is shown. 

 

NOTE: While cycling through the settings, the current setting will 
not flash, but the other settings will flash.

4. Press START to save the drying setting.

5. The drying setting you selected will become your new preset 

drying setting for all Auto Dry cycles.

Use the Drying Rack to dry items such as sweaters and pillows 
without tumbling. The drum turns, but the drying rack does not 
move. 

If your model does not have a drying rack, you may be able to 
purchase one for your model. To find out whether your model allows 
drying rack usage and for information on ordering, please refer to 
the front page of the manual or contact the dealer from whom you 
purchased your dryer. 

NOTE: The drying rack must be removed for normal tumbling. Do 
not use the automatic cycle with the drying rack.

1. Open dryer door.

2. Place drying rack inside dryer drum, positioning the back wire on 

the ledge of the inner dryer back panel. Push down on front edge 
of drying rack to secure at the front of the dryer.  

3. Put the wet items on top of the drying rack. Leave space between 

the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying rack. 

4. Close the door.

5. Press the POWER button.

6. Select Timed Dry Cycle and select a temperature (see following 

chart). Items containing foam, rubber, or plastic must be dried on 
a clothesline or by using the Air Only temperature setting.

7. You must select a time by pressing TIME ADJUST Up or Down. 

Reset time as needed to complete drying. Refer to the following 
table.

8. Press (and hold) START button (about 1 second).

This chart shows examples of items that can be rack dried and the 
suggested cycle, temperature setting and drying time. Actual drying 
time will depend on the amount of moisture items hold.

Block to shape and lay flat on 
the drying rack.

Timed Dry 

Low

60

Cotton or polyester fiber filled

Timed Dry 

Low

60

Foam rubber filled

Timed Dry

Air Only 

(no heat)

90

Timed Dry

Air Only 

(no heat)

90

*(Minutes) Reset time to complete drying, if needed.