Haier CGDE700AW 用户手册

4. Press "Temp" button to set a suitable drying temperature.

•  After switching on, the dryer sets corresponding temperature adapting to 

different program selected. If other drying temperature is wanted, press "Temp"
button to enable such a selection.

5. Press "Signal" button, a buzzer will sound upon end of a cycle.

•  After switching on, the dryer automatically sets buzzer at "Softer", while the 

user may define three prompt sound conditions "Louder", "Softer" and "Off".

6. Press "Wrinkle Saver"button to select a suitable reserved drying program.

•  After powering on, the dryer delay start drying program automatically sets 

as disabled. When you desire a drying cycle after a delay time, press 
"Wrinkle Saver" button to set wrinkle saver drying program. After initial 
pressing, the LED display indicates 3 hrs, which will be increased until 24 hrs 
by an increment 1 hr with every pressing. Press again will display drying time. 
Here if press again, it will repeat from 3 hrs. If keep pressed for 1.5 seconds, 
LED display will increase continuously.

•  When "Wrinkle Saver" is enabled, your selected program indicator turns off 

while "Wrinkle Saver"indicator and remaining reservation time indication turn 
on. During reserved period, pressing "Wrinkle Saver" button can indicate 
reserve status.

•  To change operating program or cancel delay, you should press “OFF” and 

re-select a new cycle.

7. Press "Touch Up" button to select wrinkle-proof drying mode.

•  Use the "Touch Up" cycle to continue drying if clothes are still damp after the 

Automatic cycle.

•  You can also use the "Touch Up" cycle to remove wrinkles from clean 

clothes which packed tightly in a suitcase or closet.

8. Press "Start/Pause" button

•  When starting the machine, first close the door and then press this 

button.

•  If pause is needed during machine operating, press this button. Pressing 

again will resume operation.