Maytag W10201177B 用户手册

Gather the required tools and parts before starting installation. Read and follow the 
instructions provided with any tools listed here.  

Remove parts package from dryer drum. Check that all parts were included.

Check local codes. Check existing electrical supply and venting and see “Electrical 
Requirements” and “Venting Requirements” before purchasing parts.

Mobile home installations require metal exhaust system hardware available for purchase from 
the dealer from whom you purchased your dryer. For information on ordering, please refer to 
the “Assistance or Service” section. You may also contact the dealer from whom you 
purchased your dryer.

■

Mobile home installation kit. Ask for Part Number 346764.

■

Metal exhaust system hardware.

■

A location that allows for proper exhaust installation. See “Venting Requirements.”

■

If you are using a power supply cord, a grounded electrical outlet located within  
2 ft (610 mm) of either side of the dryer. See “Electrical Requirements.”

■

A sturdy floor to support the total weight (dryer and load) of 200 lbs (90.7 kg). The 
combined weight of a companion appliance should also be considered.

■

Cold water faucets located within 4 ft (1.2 m) of the water fill valves, and water pressure 
of 20-100 psi (138-690 kPa). You may use the water supply for your washer using the “Y” 
connector and short hose (if needed) which are provided.

■

20-100 psi (138-690 kPa) for best performance.

■

A level floor with a maximum slope of 1" (25 mm) under entire dryer.

■

Flat-blade screwdriver

■

Adjustable wrench that opens to  
1" (25 mm) or hex-head socket wrench 
(for adjusting dryer feet)

■

8" or 10" pipe wrench

■

8" or 10" adjustable wrench (for gas 
connections)

■

Pipe-joint compound resistant to LP gas

■

Pliers

■

Tin snips (new vent installation)

■

Level

■

Vent clamps

■

Caulking gun and compound (for 
installing new exhaust vent)

■

Tape measure

■

Knife