Hitachi CU-HD1000 用户手册

 

6

 

23  Genlock connectors (BNC) 

Input for tri-level sync signal or black burst signal 
for genlock operation. 

24  AC IN connector 

Input for AC power supply. 

25  FG terminal 

Frame ground terminal. 

26  Fiber connector 

Connect Fiber cable.   

27  Receiver Level LED 

The strength of the arriving light signal via fiber 
cable is indicated by position of lighting LED. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
ndicate the receiver level approximately 
GREEN1: -3dBm to -8dBm (Normal) 
GREEN2: -8dBm to -11dBm 
YELLOW: -11dBm to -14dB (Warning) 
RED: under -14 dB (Alarm) 
 
 

28  REMOTE1 connector 

Connection for the optional camera control panel or 
setup control unit. 

29  RS-232C connector 

Use for camera control via RS-232C. 

30  REMOTE2 connector 

Connection for the optional camera control panel or 
setup control unit. 

31  TALLY OUT connector 

Contact outputs for tally signals. 

32  COMMUNICATION connector 

Intercom and tally inputs from external system. 

33  MIC REMOTE connector 

This connector is used to select the MIC1 and 
MIC2 amplifier gains. 

34  WFM CONTROL connector 

This connector is used to select the display mode of 
the waveform monitor. 

35  MIC OUT1 connector (XLR 3 pin) 

Outputs MIC1 audio signals from a camera or the 
CA-HF1000 at 0 dBm. 

36  MIC OUT2 connector (XLR 3 pin) 

Outputs MIC2 audio signals from the CA-HF1000 
at 0 dBm. 

37  RJ-45 connector 

This connector is used to connect expanded 
functions such as a remote controller. 

The TALLY input can be contact or voltage supply. 
Set the TALLY switches according to the systems 
connected to CU-HD1000 rear panel 
COMMUNICATION connector. 

GREEN1
GREEN2
YELLOW
RED