JVC GR-DVL355 说明手册

 EN

1. No power is supplied.

2. “SET DATE/TIME!” appears.

3. Recording cannot be

performed.

4. There is no picture.

5. The focus does not adjust

automatically.

6. The cassette will not load

properly.

7. The memory card will not

load properly.

8. Snapshot mode cannot be

used.

1. • The power is not connected

properly.

• The battery is dead.

2. • The date/time is not set.

• The built-in clock battery has

run out and the previously set
date/time has been erased.

3. — For Video Recording —

• The tape’s erase protection tab

is set to “SAVE”.

• The Power Switch is set to

“

” or “OFF”.

• The VIDEO/DSC Switch is set

to “

”.

• “TAPE END” appears.
• The cassette holder cover is

open.

— For D.S.C. Recording —
• The VIDEO/DSC Switch is set

to “VIDEO”.

4. • The camcorder is not getting

power, or some other
malfunction exists.

5. • Focus is set to the Manual

mode.

• The recording was done in a

dark place, or the contrast
was low.

• The lens is dirty or covered

with condensation.

6. • The cassette is in the wrong

position.

• The battery’s charge is low.

7. • The memory card is in the

wrong position.

8. • The Squeeze mode is

selected.

1. • Connect the AC Adapter

securely (

 pg. 9).

• Replace the dead battery with

a fully charged one
(

 pg. 8, 9).

2. • Set the date/time (

 pg. 11).

• Consult your nearest JVC

dealer for replacement.

3. • Set the tape’s erase protection

tab to “REC” (

 pg. 12).

• Set the Power Switch to “

”

or “

” (

 pg. 17).

• Set the VIDEO/DSC Switch to

“VIDEO”.

• Replace with new cassette

(

 pg. 12).

• Close the cassette holder

cover.

• Set the VIDEO/DSC Switch to

“

”.

4. • Turn the camcorder’s power

off and on again (

 pg. 17).

5. • Set Focus to the Auto mode

(

 pg. 43).

• Clean the lens and check the

focus again (

 pg. 77).

6. • Set it in the right position

(

 pg. 12).

• Install a fully charged battery

(

 pg. 8, 9).

7. • Set it in the right position

(

 pg. 14).

8. • Disengage the Squeeze mode

(

 pg. 48).

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.