JVC GR-AX310 用户手册

To vary the length of the focal lens and
produce zoom in/out effect.

Zoom In
1) Pull the power zoom switch down

toward “T”.

Zoom Out
2) Push the switch up toward “W”.

● The further the power zoom switch is

pushed or pulled, the faster the zoom
speed becomes.

● Focusing may become unstable during

zooming. In this case, set zoom while in
Record–Standby, set manual focus or
Focus Lock (

Z

 pg. 20), then zoom in or

out in RECORD mode.

To check end of last recording for
confirmation.

1) Press “

” for less than 2 seconds during

Record–Standby mode.
• Tape is rewound for about 2 seconds

and played back automatically, then
pauses in Record–Standby mode for
next shot.

Distortion may occur at start of playback.
This is normal.

To re-record certain segments.

1) Make sure camcorder is in

Record–Standby mode.

2) Press either RETAKE button to reach start

point for new recording.

3) Press Recording Start/Stop to start

recording.

Noise may appear during Retake.
This is normal.

To give you automatic access to any selected
point on a recording. Auto Marking and
Manual Marking are available.

Auto Marking
An index code is always marked to start the
first recording on a new date after a cassette
is inserted.
Manual Marking
1) Press VISS once to place index code.

INDEX blinks in the viewfinder during
marking.

● If VISS is pressed during

Record–Standby mode, the mark is
placed where START/STOP is pressed.

● If the date changes during a recording, it

becomes the first recording of the new
date and an index mark is placed at that
point.