John Deere AC-G13010S 用户手册

Operator’s Manual

Operation

OPERATION

NOTE: Read Operator’s Manual carefully before operating this

unit. Be certain to block the wheels to prevent the unit

from moving while operating. Always make sure the

unit is level and properly grounded. Check engine oil

before starting.

1. Turn the idle control switch to the OFF position. (See Fig.

2. Move choke lever to full choke. If re-starting a warm engine,

the choke should be left in the off position. (See Fig. 4)

3. Turn the key to the START position, hold until engine starts.
4. When the engine starts, release key, allowing it to return to

the ON position.

NOTE: Do not crank the engine continuously for more than

30 seconds at a time. If the engine does not start, allow

for a 3 minute cool down period between starting

attempts. Failure to follow these guidelines can damage

the starter motor.

If the starter does not turn the engine over, shut off

the starter immediately. Do not make further attempts to

start the engine until the condition is corrected. Do not

jump start using another battery.

5. Slowly move choke lever to no choke.
6. Allow unit to run two (2) minutes to warm-up.
7. Test the GFCI receptacle(s) on the unit. Push the test button.

The reset button should pop out and there should be no

power at the receptacle. Apply a test load or lamp to each

receptacle to verify. IF THE RESET BUTTON DOES NOT

POP OUT, DO NOT USE THE RECEPTACLES(S). SEE

DEALER FOR SERVICE IMMEDIATELY.

8. If GFCI receptacle(s) test correctly, firmly push the reset

button to restore power. A distinctive click should be heard or

felt when this is complete. IF THE RECEPTACLE(S)

DO NOT RESET PROPERLY, DO NOT USE THE

RECEPTACLE(S). SEE DEALER FOR SERVICE

IMMEDIATELY.

9. Turn idle control switch to ON position. Loads can now be

applied to unit.

NOTE: This engine is equipped with a “Low Oil” shutdown

system for engine protection. The engine stops when

the oil level gets too low. The engine will not restart

without adding oil. Refer to Preparing the Generator;

Engine Fuel Capacity for instructions on adding oil.

(Fig. 3)

(Fig. 4)