VIVOTEK FD6121V 用户手册

 

 

 
 

 
 

 

 

 

 

- 4 - 

 

www.vivotek.com 

T: 886-2-82455282 
F: 886-2-82455532 

 
 

Please verify that your product package contains all the accessories listed in the 
foregoing Package Contents. Depending on the user’s application, an Ethernet cable 
may be needed. The Ethernet cable should meet the specs of UTP Category 5 and not 
exceed 100 meters in length. 
 

  Connect the power adapter jack to the Network Camera before plugging in to the 

power socket. This will reduce the risk of accidental electric shock. 

 
Upon powering up, the device runs through a self-test procedure and the LEDs will 
blink between green and red for a few times. If self-test passes, the green LED will 
shut off while the red LED is constantly on and the Network Camera will be on 
stand-by and ready for software installation. If self-test fails the red LED will blink 
several times. Refer to Appendix A for troubleshooting. 
 

Make sure the Ethernet is firmly connected to a switch hub; then, plug in the power 
adapter. If the LED turns out to be steady green after self-test, go to next paragraph 
“Software Installation”.   
 
The Network Camera provides a general I/O terminal block with one digital input and 
one relay switch for device control. Pin 3 and Pin 4 can be connected to an external 
sensor device and the state of voltage can be monitored from the initial state 'LOW'. 
The relay switches Pin 1 and Pin 2 can be used to turn on or off an external device.