Nikon DS-2MBWC 用户手册

 

VI Basic Operations 

 

CAMERA 

 

 

2  Photographing Images 

- 57 - 

•  In File Settings of the SETUP menu, set the source to “s5M” or “s2M” (high picture 

quality). 

•  In Additional Settings of the SETUP menu, set External Out to “OFF” (without shutter 

delay). 

Check the screen for any abnormality. If no problems are found, save the image. 

NOTE:  If you are photographing a dark subject that requires a long exposure time, 

use the camera head in a cool place to allow for its temperature to decrease. 
This will help to reduce star-shaped noise and increase camera 
performance. 

 

 

 

When you photograph an image with synchronized lighting using a stroboscope plugged into the 
EXTERNAL OUT connector, observe the following precautions as you set up the DS-L1. 

 

•  Select “ON” for External Out in Additional Settings on the SETUP menu and press    SAVE . 

This setting enables output of a synchronizing signal.   

•  The stroboscope is synchronized when the shutter speed of the DS-L1 is in the following 

range: 
5M cameras 

5Mi mode: 1/3 s to 1 s 

 

 

1.3Mp and 1.3Mi modes: 1/7 s to 1 s 

2M cameras 

1/15 s to 1 s 

Select “MANU” for exposure mode and set the shutter speed within the above range. 

•  No noise reduction functions are supported. Select    NR OFF    and leave it selected while in 

use. 

•  The DS-L1 does not have an automatic exposure function for stroboscope. Use the 

automatical-brightness adjustment function of a stroboscope or select manual exposure in 
the DS-L1 settings. 

•  Adjust the white balance from a frozen image, following the procedure described below. 

1) 

While photographing a uniformly white subject, press the freeze button to freeze 
the display. (At this time, the stroboscope will flash. Be careful to avoid 
overexposure.) 

2） 

Press the    WB    button, then deselect freeze. 

•  The stroboscope emits light when you press the CAPTURE button to save an image or the 

freeze button to freeze the display. Freeze the display before saving an image; this will 
allow you to check the photographic conditions. 

NOTE:  Compared to ordinary photography, there is a shutter delay in strobe 

photography because the stroboscope emits light only after you press the 
CAPTURE button.