Canon EOS1DBODY 用户手册

372

If a problem occurs with the camera, first refer to this Troubleshooting 
Guide. If this Troubleshooting Guide does not resolve the problem, 
contact your dealer or nearest Canon Service Center.

 

Do not recharge any battery pack other than a genuine Canon Battery 
Pack LP-E4N or LP-E4.

 

See pages 32 and 33. If you are recharging Battery Pack LP-E4N with 
Battery Charger LC-E4 and all three Charge level lamps blink in green, 
use the charger to check the battery pack’s recharge performance (p.31).
• If a Charge level lamp lights up, you can keep using the battery pack. 

However, if the battery pack’s recharge performance is low, replacing 
the battery pack with a new one is recommended.

• If no Charge level lamps light up, the battery pack is faulty. Remove 

the battery pack from the charger and consult your dealer or nearest 
Canon Service Center.

 

Make sure the battery is properly installed in the camera (p.34).

 

Make sure the card slot cover is closed (p.35).

 

Recharge the battery (p.30).

 

If the power is turned off while an image is being recorded to the card, the 
access lamp will remain on/continue to blink for a few seconds. When the 
image recording is completed, the power will turn off automatically.

The camera does not operate even when the power switch is 
set to <1>.

The access lamp still blinks even when the power switch is 
set to <2>.

COP

Y